Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
It has been developed for commercial installations, particularly those where there are obstructions at floor level which may impede the air flow from the downflow heaters in the range. (characteristics ) 1. Input is 17.4kW (Output is approximately 13.6kW). The RHFE-1510F is suitable for heating large spaces such as offices, schools, rooms, etc. 2. The air discharge is at the top of the appliance, this helps to provide good air circulation in areas where obstructions such as desks and shelves would obstruct a downflow heater. 3. The horizontal louvres are manually adjustable, and the vertical louvres have an automatic swing’ function which can be used to sweep the air flow from left to right, or can be stopped in a particular direction. 4. Ignition is electronic, with push button control. 5. Temperature control is by electronic thermostat. 6. The control panel door has a lock which can be used to prevent the controls being tampered with. 7. Air for combustion is taken from the outside, keeping the room air clean. This heater must be installed correctly by an authorised person, and the installation must conform to local regulations, The installation must also comply with instructions supplied by Rinnai. o ONTENTS IMPORTANT NOTES ..................................................... 5 NAME AND FUNCTION OF EACH PART ......11 OPERATION INSTRUCTIONS..............................12 PRODUCT INSTALLATION......................................15 MAINTENANCE ...........................................................27 PRE SERVICE CHECK...............................................28 TROUBLESHOOTNG THE HEATER ............29 SPECIFICATIONS...............................................................30 SERVICE CONTACT POINT ..............................31 © ; As the purchaser of this high quality Rinnai Space Heater you are provided with the following conditional warranty. Heat Exchanger: 5 years* *Full Heat Exchanger replacement (parts only) in the first five years, thereafter reducing as follows, subject to conformity. A replacement heat exchanger will be supplied at the normal selling price less the following discounts. Year 6: 80% discount Year 7: 60% discount Year 8: 40% discount Year 9: 20% discount Year 10: 10% discount This warranty does not cover cleaning and normal wear and tear, calls of this nature may be chargeable. Please check the troubleshooting chart on page 29 before asking for a service call. You may be able to overcome the problem, or the heater may be operating normally. Service calls to a heater that is operating normally may be chargeable, even if the heater is under warranty. The installer is responsible for the heater's correct installation. CONDITIONS 1. It is a condition of this warranty that the heater shall have been serviced annually during its lifetime by a suitably qualified engineer, and that it must have been installed and used in accordance with these instructions. 2. Failing to use genuine Rinnai spare parts, or attempting to repair the appliance yourself may invalidate the warranty. 3. The serial number of the heater must be supplied prior to any claim being processed. All other Parts: Labour: 1 year 1 year 9 IMPORTANT INFORMATION 1. Gas safety (Installation & Use) regulations 1998 are the ‘Rules in force’. In your own interest and that of safety, it is law that all gas appliances are installed by competent persons in accordance with the above regulations. Failure to install appliances correctly could lead to prosecution. Other persons should NOT attempt to install this equipment. 2. Unpack the appliance and check it carefully. If it appears to have any defects or damage DO NOT INSTALL, contact your supplier. 3. The heater is intended to be used to raise the temperature in a room or office, etc. Do not use it for any other purpose without consulting Rinnai UK. 4. This appliance is safe if correctly installed and sited. Please comply carefully with these instructions. 5. This appliance is to be used with Natural Gas (G20) or Propane (G31) only. The data plate on the side of the unit will show which gas it is set up for. 6. Installation must be carried out in accordance with the current issue of the following: •Building regulations issued by the Department of the Environment and Building Standards (Scotland) Regulations. •I.E.E. Wiring regulations for electrical installations. •Gas safety (Installation and Use) Regulations current issue. •BS 5871 part 1:2001 •BS 5440 part 1 and 2 •BS 6891 •BS 5482 •Local byelaws •Health and safety at work etc. Act 1974 •Children and Young persons act 1933, revised 1952 •Such other specifications and regulations that may supersede or complement the above documents. v J o IMPORTANT NOTES caution" i Do not use for any other purpose except heating. ■ These clearances should be maintained at all times. 250mm i Do not allow curtains or other flammable materials to come into contact with the unit. ...