Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
No heating will occur in this mode. 4. For models with the Oscillating feature, slide the lever on the base of the unit to “Oscillation On” (C). 5. For models with a built-in Digital Thermometer, consult the thermometer to see the area temperature. Depending on the model, it will be displayed in either °F or °C (D). The digital thermometer runs on batteries and is not affected by whether or not the unit is plugged in. The batteries are already installed. To activate the thermometer, turn the unit over and pull the plastic TAB out of the battery cover on the under side of the unit. Batteries have an average life of approximately a year. To change the batteries, unscrew the battery cover on the underside of the unit and pull on the ribbons to pop the old batteries out. Replace the batteries with new LR44 (or AG13) Cells by placing them with the flat sides (+) facing in toward each other. Replace the battery cover and snap in place. Do not overtighten the screw. To preserve battery-life, you may want to remove the batteries from unit before storing during the off season. SPECIAL FEATURES and the Advanced Safety Technology™ (AST) System 1. This unit is equipped with a safety auto-off, plus a safety thermal fuse and CAUTION light. If the unit experiences excessive heat, the safety auto off will shut off the unit, and the CAUTION light will go on. If this happens, move the Lever to Off immediately. Be sure the front and back grilles are not blocked and nothing is restricting airflow. If the CAUTION light stays on, unplug the unit, let it cool down, and wait 10 minutes before plugging it back in to operate. Readjust your temperature or room settings. If the unit fails to operate after 10 minutes, it may mean the heater has internal damage and that the thermal fuse has been tripped so the heater can no longer operate. 2. The Motion Off Detection Feature will cut the power if the unit falls over in any direction or is lifted (such as if you move it to another part of the room). The Tip-over switch will cut the power if the unit is knocked over forward or backward (for example, if a pet accidentally tips it over). Both are controlled by the Tip-over switch on the bottom of the unit. Do not attempt to defeat this safety feature. 3. The Power Indicator shows that the heater is switched on and operating. It continues to glow even if the thermostat has cycled and the heating elements are off. Note that even though this unit has a cool-touch housing, both the front and back grilles will get hot. Be careful not to touch them. 4. Frost Watch: When the heater is plugged in and the power indicator is on, you can select any setting for room size (depending on your model) and leave the thermostat control on the FROST WATCH or lowest setting. Your unit will remain Off unless the temperature drops below (40° F/ 4°C). If this happens, Frost Watch will automatically cycle the heater/fan On. Care and Cleaning This appliance is permanently lubricated and will not require additiona...
Эта инструкция также подходит к моделям:Электрообогреватели - BDCH100-301 (535.84 kb)