Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
rise and in “OFF” position Double line break thermostats have an “OFF” switch that is open only when the thermostat is put in the “OFF” position To heater Power supply Single Line Break Thermostat L2 L1 (HOT) Breaks on temp. rise Single line break thermostats DO NOT have an “OFF” position and will operate at a temperature below its minimum set point To heater Power supply (1 Figure. 3 Wiring Compartment Dimensions 6.75 (153,2) CAUTION ! Figure 4. NOTE: Make sure the caution label with the word “TOP” is at the top of the heater For most efficient operation locate heaters along outside secured to wall stud. of the knockouts wiring diagram sup- If front cover was removed, reinstall by hooking the top edge Then push down to latch onto the thermostat for installa- 6 for typical ther- to the bare copper coming to the heater the desired wiring connect the power supply BOTTOM MOUNTING HOLES prevent a possible drive the screws TOP MOUNTING PERFORATIONS Double Line Break Thermostat L2 L1 Breaks in “OFF” position Breaks on temp. rise and in “OFF” position Double line break thermostats have an “OFF” switch that is open only when the thermostat is put in the “OFF” position To heater Power supply Single Line Break Thermostat L2 L1 (HOT) Breaks on temp. rise Single line break thermostats DO NOT have an “OFF” position and will operate at a temperature below its minimum set point To heater Power supply (1 Figure. 3 Wiring Compartment Dimensions 6.75 (153,2) ! WARNING wire connections are 3 OPERATION 1. After the baseboard system has been completely installed, all thermostats should be turned to LOW or NO HEAT. Then turn on breakers. Wait 3 to 5 minutes and check to see that none of the heaters are operating. If operating, disconnect power and check wiring. If none are operating then turn thermostats to highest position and wait 3 to 5 minutes. Check to see that all heater(s) are operating. Should any not be operating, disconnect power and check wiring. 2. Allow entire system to operate steadily for 1/2 hour. This should remove oily residue from manufacturing. (Some smoking may occur). 3. Select the setting for comfort on all thermostats. CLEANING Because of the convection heating principle which depends on air circulation through the finned element, dust will collect between the fins. The heater should be cleaned regularly for maximum efficiency. Before cleaning be sure the heater is off and the element is cool. A vacuum cleaner with a brush attachment may be used for cleaning. The finish of the heater may be cleaned with a slightly damp rag if desired. PAINTING Painting of this baseboard is not necessary unless to match room decor. To paint, first rough up the exterior with steel wool. Paint only the exterior of the cabinet. Do not allow paint on the element and high limit capillary tube. Use a high quality enamel paint. HOW TO ORDER REPAIR PARTS In order to obtain any needed repair or replacement parts, warranty service or technical information, please contact Marley Engineered Products Service Center toll- free by calling 1-800-642-HEAT. When ordering repair parts, always give the information listed as follows: 1. The Part Number 2. The Model Number 3. The Part Description 4. Date of Manufacture NAMEPLATE MODEL NO. C2570WC DATE CODE 1294 VOLTS AC 60HZ WATTS AMPS 277/240/208 2500/1900/1450 9.1/8.0/7.0 54E...
Эта инструкция также подходит к моделям:Электрообогреватели - 1800 (92.78 kb)
Электрообогреватели - 2500 (92.78 kb)
Электрообогреватели - C1800 (92.78 kb)