Оценок - 2, средний балл: 4 ( )

Производитель: Cadet Размер: 209.41 kb Название файла: Язык инструкции:

A Cadet wall thermostat is recommended for optimum performance, or you may prefer the convenience of a built-in EBKN DPST thermostat kit. For instructions on wiring a thermostat, see the instructions that were included with your thermostat. If you are installing a thermostat, refer to the section later in this guide titled “Step 3: Thermostat” prior to installing the baseboard. PLACEMENT For best results, install the Softheat baseboard heater under a window, along an outside wall, or as close as possible to an outside door. Follow these instructions for selecting an ideal area of installation: DO NOT INSTALL ANY BASEBOARD BELOW AN ELECTRICAL OUTLET DO NOT INSTALL ANY BASEBOARD VERTICALLY. MOUNT THE BASEBOARD HORIZONTALLY ONLY WARNING Do not mount the heater against combustible low-density cellulose fiberboard. WARNING To reduce risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater. • The seam at the junction of the wall and floor behind the heater should be caulked to prevent dust from being drawn into the room. • Heater should be set flush against surface of the wall. • Remove any obstructions between the back of the unit and the surface of the wall. • Baseboard heater may sit directly on any floor surface, including carpet. • Maintain at least 12 inches minimum clearance from objects hanging above (i.e. drapes). WIRING Wire connection is standard from the left side of the baseboard heater. Determine on which side of the baseboard you are making wire connections by locating the supply wires. Heaters may be purchased special order as a right side wire connection configuration. You must locate the supply wires before mounting the heater. See section titled “Step 3: Thermostat” prior to wiring the baseboard if you are installing a wall thermostat. VOLTAGE (ALL MODELS) It is extremely important that you verify the electrical supply wires are the same voltage as the heater (i.e. 120 volt heater to 120 volt power supply and 240 volt heater to 240 volt power supply). If replacing an existing heater check the labels of the old heater and replace using same voltage. Hooking a 240 volt heater to a 120 volt power supply will drastically reduce the heater’s output. Hooking a 120 volt heater to a 240 volt power supply will destroy the heater. LEVEL The Softheat baseboard heater must be properly leveled when installed, in order for the heating chamber to function properly. INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS STEP 1: Mount Heater to Wall 1. Locate wall studs closest to supply wires and position heater (See Figure 1). NOTE: Wire connection is from left side only on standard models. SUPPLY STUDS FLOOR FINISHED WALL Figure 1 2. Carefully remove front cover from heater by lifting cover up from the bottom, and then outwards. Set aside. 3. Remove wiring compartment cover, held by one screw, from side you wish to wire. (Figure 2). 4. Remove slotted knockout closest to the supply wires and instal...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: