Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
For safety, follow all installation, operation and maintenance directions. Contact local building officials about restrictions and installation inspection requirements in your area. DO NOT DISCARD THIS MANUAL: Retain for future use 7001135 12/07 Rev. 20 Dutchwest The Dutchwest models covered in this Owner’s Guide have been tested and listed by Inchcape Testing Services / Warnock Hersey of Middleton, Wisconsin. The test standards utilized were ANSI/UL 1482 for the United States and CAN/CGA - B366.2 for Canada. Dutchwest models are not listed for mobile home installations. PLEASE NOTE Please read this entire manual berfore you install and use your new room heater. Failure to follow instructions my result in property damage, bodily injury or loss of life. Save these instructions for future use. Table of Contents Specifications ............................................................ 3 Installation ..........................................................4 Clearances .......................................................12 Assembly..........................................................16 Operation..........................................................17 Maintenance.....................................................22 Illustrated Parts List..........................................30 Accessories • • • • • • • Bottom Heat Shield Clearance-reducing Rear Heat Shields Clearance-reducing Heat Shields for single-wall stove pipe 2” legs Warming shelves (Small and Large Heaters only) Two-speed convection blower Automatic thermostat for the blower Proposition 65 Warning: Fuels used in gas, wood- burning or oil fired appliances, and the products of combustion of such fuels, contain chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. California Health & Safety Code Sec. 25249.6 Patents: U.S. - D288357, 4502395, 4646712; Canada - 1235969. Other foreign mechanical patents issued. Dutchwest Specifications G F Stove Model Number A B C D E F G Log length: Maximum burn time1: Average area heated (sq. ft.)2: Range of heat output4: Maximum heat output: EPA emissions rating4 (g/h, catalytic): Weight: Loading: Flue exit position (reversible): Air controls: A C B D E 2460 2461 22” (560 mm) 25...” (654 mm) 21” (530 mm) 24...” (620 mm) 29...” (754 mm) 30” (760 mm) 16” (410 mm) 16” (410 mm) 14...” (375 mm) 14...” (380 mm) 26...” (683 mm) 27” (690 mm) 29...” (754 mm) 30” (760 mm) 19” (480 mm) 22” (560 mm) 8 hrs. 9 hrs. 700-1,400 (65-130m2) 800-1,600 (75-150m2) 7,800 - 26,800 Btu/hr. 11,300 - 26,800 Btu/hr. 35,000 Btu/hr. 40,000 Btu/hr. 1.1 1.4 380 lbs. (172 kg) 436 lbs. (198 kg) Side or front Side or front Top or rear Top or rear 2 controls 2 controls 2462 28...” (717 mm) 27” (690 mm) 33” (840 mm) 18...” (467 mm) 17” (430 mm) 30...” (763 mm) 33” (840 mm) 25” (640 mm) 12 hrs. 1,200-2,400 (112-224m2) 10,500-27,700 Btu/hr5 55,000 Btu/hr. 1.3 634 lbs. (288 kg) Side or front Top or rear 2 controls Fig. 1 Dutchwest Convection Heater specifications. 1. Maximum burn times and heat outputs are based on laboratory testing using full loads of seasoned hardwoods, and may vary in individual use depending on how the stove is operated, type and moisture content of fuels, and other factors. Maximum burn times are achieved under different operating conditions than are maximum heat outputs. 2. These values are based on operation in building code-conforming homes under typical Winter climate conditions in the northeastern U.S. If your home is of nonstandard construction (e.g. unusually well-insulated, not insulated, built underground, or if you live in a more severe or more temperate climate), these figures may not apply. Since so many variables affect performance, consult your Dutchwest Authorized Dealer to determine realistic expectations for your home. 4. Under specific conditions used during EPA emissions testing. 5. Based on preliminary results obtained during EPA emissions testing. Dutchwest Installation SAFETY NOTICE: IF YOUR DUTCHWEST CONVECTION HEATER IS NOT PROPERLY INSTALLED, OPERATED AND MAINTAINED, A HOUSE FIRE MAY RESULT. FOR SAFETY, FOLLOW ALL INSTALLATION, OPERATION AND MAINTENANCE DIRECTIONS. CONTACT LOCAL BUILDING OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA. Before you begin the installation, review your plans to confirm that: • Your stove and chimney connector will be far enough from combustible material to meet all clearance requirements. • The floor protector is large enough and is constructed properly to meet all requirements. • You have obtained all necessary permits from local authorities. Your local building official is the final authority for approving your installation as safe and for determining that it meets local and state codes. Clearance and installation information is printed on the metal label attached to the rear of the stove. Local authorities generally will accept the label as evidence that, when the stove is installe...
Эта инструкция также подходит к моделям:Электрообогреватели - 2461 (1.03 mb)
Электрообогреватели - 2462 (1.03 mb)