Оценок - 5, средний балл: 4.4
(
)
)
|
Фрагмент инструкции
2. Place the Heater on a firm, level surface. CAUTION: Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The unit may leave a residue that could darken, stain or leave permanent blemishes on the finish of certain furniture surfaces, including wood surfaces, and/or hardwood floors. 3. Make certain the Heater Power Knob is in the OFF (0) position before plugging unit into an outlet. 4. Plug the cord set into a 120 volt outlet. Be sure that the plug fits tightly into outlet. When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater. 5. When the Heater is initially plugged in, the red light will come on indicating that there is power to the unit. The red light will remain lit until the Heater is unplugged from the electrical outlet 6. Turn the Power Knob to the desired setting. () for Fan Only, (1) for Low Heat and (2) for High Heat (1500 Watts). 7. For Heater operation, turn the Thermostat Knob to the highest setting (). (See Thermostat Instructions) 8. To turn the Heater off, turn the Power Knob to OFF (0) and unplug the Heater from the electrical outlet. DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG HEATER BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE HEATER IS ON OR PLUGGED IN. THERMOSTAT INSTRUCTIONS (Figure 2) 1. Set the thermostat knob by turning clockwise to the (+) and allow the Heater to warm up the room. 2. When the desired comfort level is reached, lower the thermostat until the unit shuts off. This is done by turning the Thermostat knob counter-clockwise towards (-). 3. The Heater will now automatically maintain the desired comfort level by cycling ON and OFF. For continuous heat, set the thermostat towards (+). NOTE: It is recommended you adjust your thermostat with each use. Day to day changes in room and outdoor temperature will affect the position at which your thermostat will turn on or off. SAFETY FEATURE 1. A thermal overload protector is built in to prevent overheating. 2. If an overheat temperature is reached, the Heater will automatically shut off. It can only resume operation when the unit is reset. (See reset instructions below). To Reset Heater: 1. Unplug the Heater and wait 10 minutes for the unit to cool down. 2. After the 10 minutes, plug the Heater in again and follow the OPERATION INSTRUCTION described in this instruction manual. SAVE THESE INSTRUCTIONS INSTRUCCIONES IMPORTANTES DE SEGURIDAD TROUBLE SHOOTING TIPS If your heater shuts off unexpectedly or fails to operate, the above-mentioned safety feature may have been activated to prevent overheating. 1. Be sure the power cord is plugged i...
Эта инструкция также подходит к моделям:Электрообогреватели - 3DZR7 (176.69 kb)
Электрообогреватели - 3DZR7 (176.69 kb)
Электрообогреватели - 8945 (176.69 kb)