Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
. A WARNING ■ Before testing, carefully wipe off spilled fuel. Put the plug as far away from the spark plug hole as possible. , Ground the side of the electrode to any engine ground. Starting failure Is there a strong spark_ across the 'electrode? Is there 'enough compression? “ 1. Remove the plug and connect it to the plug cap. Pull the starter handle while putting the plug against the engine ground. 2. Try with a new plug if the spark is weak or no spark flies. 3. The ignition system is faulty if there is no spark with a new plug. Take your pump to your nearest Robin dealer. 1. Pull the starter handle slowly and check if resistance is felt. 2. If little force is required to pull the starter handle, ; check if the spark plug is tightened firmly. 3. If the spark plug is loose, tighten it. 4. If compression is still low, consult your nearest dealer. is the spark ■plug wet with— fuel? — 1. Choke (close choke lever) and pull the starter handle five or six times. Remove the plug and check if its electrode is wet. If the electrode is wet, fuel is well supplied to your engine. — 2. When the electrode is dry, check where the fuel stops, (Check the fuel intake of the carburetor and fuel strainer intake.) 3. In case the engine does not start with well supplied fuel, try using different fuel. -13 - 10. PREPARATIONS FOR STORAGE Drain all water from the drain plug. rfCAUTIONl- When retightening drain plug, be sure to clean the drain plug and the thread of casing .Otherwise, the thread may be damaged. ■ Remove the strainer cup, and open the strainer cock to discharge the fuel from the fuel tank. Remove the carburetor float chamber bolt from the bottom and discharge fuel from the carburetor. (NO SMOKING !) ■ Change the used engine oil with fresh oil. Remove the spark plug, pour about 5 cc of engine oil into the cylinder, slowly pull the starter knob of the recoil starter 2 or 3 times, and tighten the spark plug. ■ Slowly pull the recoil starter knob until resistance is felt and leave it in that position. i Store the pump in a dry place free from sand or dust. Always keep the pump covered. - 14 - 11. OIL SENSOR INSTRUCTIONS OIL SENSOR (a) The oil sensor detects the fail in oil level in the crankcase and automatically stops the engine when the oil level falls down below the predetermined level. (b) When engine has stopped automatically, check the oil level. Refill engine oil to the upper level and restart the engine. (c) If the engine does not start by usual starting procedures, check the oil level. ¡-[CAUTION] ■ ■ - ■ Do not remove OIL SENSOR PROBE when refilling with oil. Remove oil filler cap on the opposite side of carburetor. - 15 - MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects from workmanship and materials for the period of ONE YEAR from the date of original purchase. Should any trouble develop during this one-year period, return the COMPLETE tool, freight prepaid, to one of Makita’s Factory or Authrorized Service Centers. If inspection shows the trouble is caused by defective workmanship or materia!, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where: • repairs have been made or attempted by others; • there is evidence of normal wear and tear; • The tool has been abused, misused or improperly maintained; • alterations have been made to the tool. Defects are due to the use of parts, accessories or attachments which are not Makita genuine products, specifically recommended for use with this tool. Damage may be caused in transit. (This must be the responsibility of the carrier.) Claims arise from regulations such as for noise levels, exhaust gas emissions, etc. This product has been operated for. racing purposes or other competitve activities. This product has been employed for powering equipment that is operated on, in or near water or explosive atmospheres. The following parts are expendable (not durable), so warranty does not apply; Expendable parts including, but not limited to: Spark plugs, packings, gaskets, rubber materials, washers, nuts, V-belt, engine oil, grease, paper elements , brushes, mechanical seal, pump impeller and volute casing. IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES FROM THE SALE OR USE OF THE PRODUCT. THIS DISCLAIMER APPLIES BOTH DURING AND AFTER THE TERM OF THIS WARRANTY. MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED WARRANTIES, INCLUDING IMPLIED WARRANTIES OF “MERCHANTABILITY” AND "FITNESS FOR A SPECIFIC PURPOSE/’ AFTER THE ONE-YEAR TERM OF THIS WARRANTY. This Warranty gives you specific legal rights, and you may also have other rights which very from state to state. Some states do not allow the exclusion of limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states...
Эта инструкция также подходит к моделям:Электрообогреватели - Pump EW200R (396.98 kb)
Электрообогреватели - Pump EW400R (396.98 kb)