Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Heater will remain hot for a time after shutdown. Allow surface to cool before touching. Carefully supervise young children when they are in the room with heater. When using the hand-held remote accessory, keep selector switch in the OFF position to prevent children from turning on burners with remote. Keep the appliance area clear and free from combustible materials, gasoline, and other flammable vapors and liquids. 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases. 2. Do not place propane/LP supply tank(s) inside any structure. Locate propane/LP supply tank(s) outdoors (propane/LP units only). 111161-01D SAFETY INFORMATION Continued 3. To prevent performance problems, the use of a propane/LP fuel tank of less than 100 lb. capacity is not recommended (propane/LP units only). 4. If you smell gas • shut off gas supply • do not try to light any appliance • do not touch any electrical switch; do not use any phone in your building • immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions • if you cannot reach your gas supplier, call the fire department 5. This heater shall not be installed in a bedroom or bathroom unless installed as a vented appliance (see Installing Damper Clamp Accessory for Vented Operation, page 11). 6. Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes, and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. A dirty chimney flue may create and distribute soot within the house. Inspect chimney flue for damage. If damaged, repair flue and firebox before operating heater. 7. Do not burn solid-fuel in a masonry or UL127 factory-built fireplace in which a vent-free room heater is installed. 8. If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fireplace will cause glass to burst. Make sure there are no obstructions across openings of fireplace. 9. This log heater is designed to be smokeless. If logs ever appear to smoke, turn off heater and call a qualified service person. Note: During initial operation, slight smoking may occur due to log curing and heater burning manufacturing residues. 10. To prevent the creation of soot, follow the instructions in Cleaning and Maintenance, page 23. 11. Before using furniture polish, wax, carpet cleaner, or similar products, turn heater off. If heated, the vapors from these products may create a white powder residue within burner box or on adjacent walls or furniture. 12. This heater needs fresh, outside air ventilation to run properly. This heater has an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS shuts down the heater if not enough fresh air is available. See Air for Combustion and Ventilation, page 5. If heater keeps shutting off, see Troubleshooting, page 24. 13. Do not run heater • where flammable liquids or vapors are used or stored • under dusty conditions 14. Do not use this heater to cook food or burn paper or other objects. 15. Do not use heater if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water. 16. Do not operate heater if any log is broken. Do not operate heater if a log is chipped (dime- sized or larger). 17. Turn heater off and let cool before servicing, installing, or repairing. Make sure the remote selector switch is in the OFF position. Only a qualified service person should install, service, or repair heater. 18. Make sure the remote selector switch is in the OFF position when you are away from home for long periods of time. 19. This heater must not be connected to any external electrical source. 20. Operating heater above elevations of 4,500 feet may cause pilot outage. 21. Provide adequate clearances around air openings. LOCAL CODES Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANSI Z223.1/NFPA 54*. *Available from: American National Standards Institute, Inc. 1430 Broadway New York, NY 10018 National Fire Protection Association, Inc. Batterymarch Park Quincy, MA 02269 Note: Where listed vented decorative logs are required, thermostat operation is not permitted. 111161-01D PRODUCT IDENTIFICATION Log Set Base Grate Piezo Ignitor Optional Remote Control Optional Selector Flame Switch Adjustment Control Knob Knob Figure 1 - Vent-Free Gas Log Heater (Logs May Vary By Model) UNPACKING CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important warranty and safety information. 1. Remove logs and heater base assembly from carton. Note: Do not pick up heater bas...
Эта инструкция также подходит к моделям:Электрообогреватели - CCL3930PRA (951.67 kb)
Электрообогреватели - Yellow Flame CCL3018NR, CCL3018PR, CCL3018NRA, CCL3018PRA, CCL3924NR, CCL3924PR, CCL3924NRA, CCL3924 (951.67 kb)