Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
6 Additional Requirements....................................... 6 Step 1 Attach Emitter Screen ............................... 6 Step 2 Attach Top Wire Guard .............................. 7 Step 3 Attach Dome to Emitter...............................7 Step 4 Attach Dome Cap ...................................7 Step 5 Gas Hook Up.......................................8 Step 6 Check for Leaks.................................... 9 Step 7 Install Access Panel..................................9 Step 8 Securing Tank .....................................10 Operation Before Turning Gas Supply ON .................................11 Before Lighting ..............................................11 Lighting....................................................11 Re-Lighting ................................................ 12 Shutdown ................................................. 12 Operation Checklist..........................................................................................13 Troubleshooting................................................................................................14 Maintenance ....................................................................................................15 Storage ............................................................................................................16 Service ............................................................................................................16 Warranty ..........................................................................................................17 Specifications ..................................................................................................18 The use and installation of this product must conform to local codes. In absence of local codes, use the National Fuel and Gas Code, ANSI Z223.1/ NFPA 54, Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 or CSA B149.1, Natural Gas and Propane Installation Code. Save these instructions for future reference. If you are assembling this unit for someone else, give this manual to him or her to save for future reference. Owner's manual: model 92000 portable outdoor heater 12/3/03 2 Endless Summer^ Safety First! Read and become familiar with this entire manual, especially the following precautions. If you are unsure of anything in these instructions, STOP and contact 1-800-762-1142 for assistance. Caution: This appliance is for outdoor use only (outside any enclosure). Always make sure there is fresh air ventilation. • Instructions to the effect that this appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building, garage or any other enclosed area. • Always maintain at least 36” clearance (top) and 24” clearance (side) from combustible materials. • Always place heater on a hard and level surface. • Do not use if the wind velocity is greater than 10 miles per hour. • Unit will operate at reduced efficiency below 40°F (5°C). • Keep sprinklers and other water sources away from burner and controls. • Always use extreme caution when near heater. Alert both children and adults to the hazards of high temperatures, especially to avoid burns or clothing catching fire. • Young children and pets should be carefully supervised when they are in the area of heater. • Do not hang clothing or other flammable materials either on or near heater. • Any guard or other protective device removed for servicing the heater must be replaced prior to operating the heater. • Certain materials or items, when stored under heater, will be subjected to radiant heat and could be seriously damaged. • Do not alter heater in any manner. • The pressure regulator and hose assembly supplied with the appliance must be used and replacements must be those specified by the manufacturer. • Inspect heater before each use. If a damaged part is detected, do not operate until an original equipment replacement part has been properly installed. Use of unauthorized parts will void warranty and create an unsafe condition. • Do not attempt to use this appliance without a functional factory-supplied gas regulator in place. If regulator becomes damaged, use only a factory-supplied replacement. • Prior to operating heater, replace any guards or protective devices removed for servicing. • During operation, do not touch burner assembly. The surface of heater’s emitter can reach temperatures approaching 1600°F. • After shutdown, do not touch burner assembly until heater has cooled (approximately 45 minutes after use). Notice: This product should not be used with any fuel other than liquid propane. Use of other fuels will detract from heaters performance and will void your warranty. Before you do anything else, read and understand all precautions in Safety First! ¿L WARNING FOR YOUR SAFETY • Purchaser assumes all risk in the assembly and operation of this unit. Failure to follow this manual’s wa...