Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
(0.9 m) away from any wall or combustible material. • With the selector knob in the OFF ° position, plug the heater into a polarized 230V outlet. • Turn the thermostat control fully clockwise to the HIGH # setting. • To turn the heater on, while turning it clockwise to the desired position (HIGH# for 1800W, or LOW > for 900W). The on light will illuminate. • When the room reaches a comfortable temperature, slowly turn the thermostat control counter-clockwise until the heater goes off. This is the point at which the thermostat setting equals the room temperature. At this setting, the thermostat will automatically turn the heater on and off to maintain this selected temperature. • If using the oscillation feature, at the point your desired temperature is reached, the heater will stop oscillating. • Turn the selector knob to OFF ° and unplug the heater when you are finished using it. Oscilation switch 5 Vt-174 5.qxd 18.05.04 11:13 Page 12 ENGLISH OSCILATION FEATURE To use this feature, push the Oscillation switch located at the top of the heater to ON. The heater will then oscillate to each side. Note: To start the Oscillation you should first set the thermostat. OTHER FEATURES • This heater is equipped with a "tip over switch" safety feature, which automatically shuts off heating element if heater is not in an upright position. Heat will resume once heater is properly oriented. • This heater is equipped with an internal High Limit Switch, which causes the unit to stop operating in the event the internal temperature exceeds normal operating temperatures. FAN OPERATION To use the unit as a cooling air circulator without heat, turn the selector knob to FAN y and the thermostat to its highest setting. IF YOUR HEATER FAILS TO OPERATE • Be sure it is plugged in and that the electrical outlet is working. • Check for any obstruction. If you find an obstruction turn the heater OFF. • Unplug the heater and wait at least ten minutes for it to cool. Carefully remove the obstruction. Plug the heaters back in and restart it as described under OPERATION. • If you still notice the same defect above mentioned, remove the plug from the socket and have the appliance serviced by authorized service personnel only. • Check that the thermostat is not set too low. With the selector knob set to a heat setting, turn the thermostat up (clockwise) until the heater restarts. 6 РУССКИЙ • Во избежание перегрузки в электрической сети или срабатывания сетевого автоматического предохранителя следите, чтобы к розетке, в которую включен данный тепловентилятор, не подключались другие электроприборы с большой мощностью потребления. • Не забывайте отключать тепловентилятор от электрической сети, если он не используется. • Следует применять тепловентилятор только в соответствии с настоящей инструкцией, иначе это может привести к возникновению пожара, поражению электрическим током или к травмам. СОХРАНИТЕ ДАННУЮ ИНСТРУКЦИЮ ИСПОЛЬЗОВАНИЕ • Данное устройств...