Оценок - 5, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Contact your authorized Fluke Service Center for recycling information. Caution Do not wet the instrument when cleaning it and in particular use only a soft dry cloth to clean the LCD win- dow. The following symbols are used on the instrument and in this manual: Caution - refer to the accompanying documentation, incorrect operation may damage the instrument. Terminal connected to chassis ground. Mains supply OFF. Mains supply ON. Alternating current. Warning - hazardous voltages may be present. EMC Compliance This instrument meets the requirements of the EMC Directive 89/336/EEC. Compliance was demonstrated by meeting the test limits of the following standards: Emissions EN61326 (1998) EMC product standard for Electrical Equipment for Measurement, Control and Laboratory Use. Test limits used were: a) Radiated: Class B b) Conducted: Class B c) Harmonics:EN61000-3-2 (2000) Class A The instrument is Class A by product category. Immunity EN61326 (1998) EMC product standard for Electrical Equipment for Measurement, Control and Laboratory Use. Test meth- ods, limits and performance achieved were: a) EN61000-4-2 (1995) Electrostatic Discharge: 4 kV air, 4 kV contact Performance A. b) EN61000-4-3 (1997) Electromagnetic Field: 3 V/m, 80 % AM at 1 kHz Performance A. c) EN61000-4-11 (1994) Voltage Interrupt: 1 cycle, 100 % Performance A. d) EN61000-4-4 (1995) Fast Transient: 1 kV peak (ac line), 0.5 kV peak (signal lines and RS232/GPIB ports) Performance A. e) EN61000-4-5 (1995) Surge: 0.5 kV (line to line), 1 kV (line to ground) Performance A. f) EN61000-4-6 (1996) Conducted RF: 3 V, 80 % AM at 1kHz (ac line only; signal connections <3 m not tested) Performance A. According to EN61326 the definitions of performance criteria are: Performance criterion A: ‘During test normal performance within the specification limits.’ Performance criterion B: ‘During test, temporary degradation, or loss of function or performance which is self-recovering’. Performance criterion C: ‘During test, temporary degradation, or loss of function or performance which requires operator intervention or system reset occurs.’ Table of Contents Title Page Introduction.................................................................................................................... 1 Before You Start............................................................................................................. 1 Mains Supply Voltage................................................................................................ 1 Externally Applied Voltages....................................................................................... 2 Controls and Connections.............................................................................................. 3 The Liquid Crystal Display......................................................................................... 4 Controls..................................................................................................................... 4 Function Keys....................................................................................................... 4 FIELD and DIGIT Keys and the Rotary Control.................................................... 5 Numeric, Units and SET Keys.............................................................................. 6 MODE Keys.......................................................................................................... 7 UTILITIES Keys.................................................................................................... 7 OUTPUT Key........................................................................................................ 7 Front Panel Inputs and Outputs................................................................................. 8 MAIN OUT............................................................................................................ 8 AUX OUT............................................................................................................. 8 EXT TRIG............................................................................................................. 8 Rear Panel Connectors............................................................................................. 9 CLOCK IN/OUT.................................................................................................... 9 VCA IN................................................................................................................. 9 SYNC OUT........................................................................................................... 9 TRIG/SWEEP OUT.............................................................................................. 10 RS232 and GPIB Interface Connectors................................................................ 10 Using the Instrument...................................................................................................... 11 Starting up................
Эта инструкция также подходит к моделям:Электрогенераторы - DDS Function Generator 271 (647.21 kb)