Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
6. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. 7. Do not use this appliance with a damaged or broken foil, as serious skin injuries may occur. 8. Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to «off», then remove plug from outlet. 9. When plugging to an electrical outlet outside the USA, use a plug adapter to match the outlet’s pin configuration. SAVE THIS INSTRUCTIONS Description Shaving 1 Shaver foil Press the on/off switch (4) to turn the shaver 2 Cutter block on. 3 Release button 4 On/off switch («start/stop») Trimmer: 5 Long hair trimmer When the long hair trimmer (5) is activated, it 6 Charging light (green) allows the controlled trimming of moustache 7 Low-charge light (red) or sideburns. 8 Special cord set Tips for the perfect shave Charging • It can take up to 14-21 days for your beard to adjust to the new shaving system. The best environmental temperature for • Shave before washing your face or taking a shower, as skin tends to swell aftercharging is between 60 °F to 95 °F / 15 °C washing. and 35 °C. • The drier the skin, the closer the shaving• Connect the shaver to an electrical outlet results will be. with the motor switched off. • Hold the shaver at right angles (90°) to the• When charging for the first time, leave the skin. Stretch the skin and shave againstshaver to charge continuously for 4 hours. the direction of beard growth. • The green charging light (6) shows that the • To maintain 100% shaving performance, shaver is being charged. When the replace your foil and cutter block everybatteries are fully charged, the charging 18 months or when worn. light intermittently blinks on and off. This indicates that the battery maintains its full capacity. • Once the shaver is completely charged, discharge the shaver through normal use. Cleaning Then recharge to full capacity. Subsequent charges will take about 1 hour. • A full charge provides up to 40 minutes of cordless shaving time depending on your The hand-held unit shall be detached from the power supply cord before cleaning. The shaver shall not be used until it has dried. beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles. • The red low-charge light glows when the shaver capacity has dropped below 20% provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves. • If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set. Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. • Next, switch off the shaver and press the release buttons. Remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. Alternatively, you may clean the shaver using the brush provided: • Switch off the shaver. Remove the shaver foil. • Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. • Put a drop of light machine oil onto the long hair trimmer and the shaver foil. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity. Replacing the shaving parts To maintain 100% shaving performance replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: 30B) Environmental notice This appliance contains rechargeable batteries. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Disposal can take place at a Braun Service Center or appropriate collection sites. Subject to change without notice. For electric specifications, see printing on the special cord set. FOR USA ONLY 2 year limited warranty (foil and cutter block excluded) Braun warrants this Braun shaver (except foil and cutter block) to be free of defects in material and workmanship for a period of two years from the date of original purchase. If the shaver exhibits such a defect, Braun will, at its option, either repair or replace it for the consumer without charge. Please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. This warranty does not cover foils, cutter blocks or damage resulting from accident, misuse, abuse, dirt, water, tamperi...