Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
-The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. -The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this causes a hazardous situation. -Do not use a damaged powerplug. -If the powerplug is damaged, always have it replaced with one of the original type in order to avoid a hazard. -Make sure the powerplug does not get wet. -Charge and store the appliance at a temperature between 15°C and 35°C. -Never immerse the charging stand in water nor rinse it under the tap. -Do not recharge the shaver in a closed pouch. -Always unplug the shaver before you clean it under the tap. -The shaver complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. EnglisH This washable shaver is not suitable for shaving in the shower. Do not immerse the shaver in water. Water may leak from the socket at the bottom of the appliance, when you rinse it.This is normal and not dangerous because all electronics are enclosed in a sealed shell inside the shaver. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Charging Make sure the appliance is switched off before you star t to charge it. Charging takes approx. 1 hour. You can also shave without charging by connecting the shaver to the mains. Charge indications ChargingWhen you start charging the empty shaver, the bottom light flashes red.When the battery contains enough power for one shave, all lights start flashing green sequentially. Battery fully charged When the battery has been fully charged, all green lights are on. - - - , , EnglisH A few hours after charging, all lights go out. Remaining battery capacity The amount of power left in the battery is , indicated by the number of lights that are on. The battery capacity is only shown when you switch the shaver on or off. -When all lights burn green, the batter y is 100% charged. -When the bottom light burns green, 20% of the batter y capacity is left. Battery running low When the battery is running low, the bottom , light turns red. When you switch off the shaver, this light flashesblinks a few times. Cordless shaving time A fully charged shaver has a cordless shaving time of up to 55 minutes. Charging the appliance Charge the shaver when the bottom light burns or flashes red. Do not recharge the shaver in a closed pouch. 1 2 3 when the battery has been fully charged. Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver Charging stand You can also charge the appliance by placing it in the charging stand, if provided. EnglisH Place the shaver properly in the plugged-in charging stand. Lift the shaver from the stand without tilting it. Using the appliance Shaving 1 Switch the shaver on by pressing the on/off button once. The blue light ring around the on/off button goes on to indicate that the motor is running. Note:When you switch the shaver on, all lights go on and then the remaining battery capacity is shown for a few seconds. 2 Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dr y face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Switch the shaver off by pressing the on/off button once. The blue light ring around the on/off button goes out. , , -- EnglisH 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). Put the protection cap on the shaver every time you have used it, to prevent damage. Trimming For grooming sideburns and moustache. 1 Open the trimmer by pushing the slide downwards. The trimmer can be activated while the motor is running. 2 Close the trimmer (‘click’). Cleaning and maintenance The light above the tap symbol starts flashing after every shave to remind you that the shaver needs to be cleaned (except when the bottomlight burns red). Regular cleaning guarantees better shaving performance. The normal way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water ever y time you have used the shaver. , EnglisH Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the appliance when you rinse it.This is normal and not dangerous. Every day: shaving unit and hair chamber 1 2 3 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button to open the shaving unit. Clean the shaving unit and the hair chamber by rinsing them...
Эта инструкция также подходит к моделям:Электробритвы - HQ8170/43 (5.51 mb)
Электробритвы - HQ8170/16 (5.51 mb)