Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
Adding water, or changing just the detergent cartridge or the water, will result in deteriorated cleaning functions. • If you operate the self-cleaning recharger, the concentrated detergent in the detergent cartridge dilutes and the water inside the tank will become a cleaning liquid. .Preparing the self-cleaning rechargerRemove the shaver and the appliance plug from the self-cleaning recharger. .... 2134. .. Cleaning with the self-cleaning rechargerCareRemove the water tank and then open the water tank cap. Wash away the old cleaning liquid and then rinse the water tank. Pour tap water up to the feed water line. • Do not let the tap water rise above the feed water line.This may cause the cleaning liquid to spill. Securely close the water tank cap and then attach the tank. Peel off the seals from the new detergent cartridge. (2 seals) • Hold the detergent cartridge horizontally. (The detergent may spill if the detergent cartridge is tilted too much.) Attach the detergent cartridge. • Replace the HydraClean™ Shaving System Solution Cartridge when the status lamp is illuminated. Use the below chart as a guide. ShavingCleaningReusability1 time/day1 time/dayapprox. 30-40 times1 time/3 daysapprox. 10-14 times1 time/weekapprox. 4-6 timesThe expiration date of the cleaning liquid is 6 months after it is opened. If you do not use the cleaning liquid for more than 6 months, throw away the detergent cartridge and the cleaning liquid. • Only use self-cleaning recharger special detergent for Panasonic shavers. • Always change the detergent cartridge and the cleaning liquid in the water tank at the same time. Adding water, or changing just the detergent cartridge or the water, will result in deteriorated cleaning functions. • If you operate the self-cleaning recharger, the concentrated detergent in the detergent cartridge dilutes and the water inside the tank will become a cleaning liquid. .Cleaning the shaver• Each time you press [SELECT], the course changes from “Clean/ Dry/Charge”.“Clean/Dry”.“Dry/Charge”.“Dry”.“Charge”. • The courses start approximately 6 seconds after they are selected. • The course will be aborted if the power is cut off. In this case, perform the course again from the beginning. • Do not detach the detergent cartridge or the water tank as the cleaning liquid may spill causing a malfunction. 12SELECTCLEANDRYCHARGESTATUSInsert the appliance plug. Plug in the adaptor. Remove the protective cap and then attach the shaver. • Turn the shaver off before attaching. • Check that the outer foil is not deformed or damaged when you are attaching the shaver. Press [SELECT] to select the course. CourseCourse selection indications . Course completion summaryOn rechargerChangeable course halfway throughOn rechargerOn shaverTime required (guide) [In the low temperature]cleandrychargecleandrychargeBacklight .Charge*.....Blinks1 hour .Clean/Dry/Charge..Blinks2 hours [+30 min] .Clean/Dry..–1 hour [+30min ] .Dry/Charge....Blinks2 h 40 min .Dry....–1 h 40 min• Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent. .Cleaning the shaver• Each time you press [SELECT], the course changes from “Clean/ Dry/Charge”.“Clean/Dry”.“Dry/Charge”.“Dry”.“Charge”. • The courses start approximately 6 seconds after they are selected. • The course will be aborted if the power is cut off. In this case, perform the course again from the beginning. • Do not detach the detergent cartridge or the water tank as the cleaning liquid may spill causing a malfunction. 12SELECTCLEANDRYCHARGESTATUSInsert the appliance plug. Plug in the adaptor. Remove the protective cap and then attach the shaver. • Turn the shaver off before attaching. • Check that the outer foil is not deformed or damaged when you are attaching the shaver. Press [SELECT] to select the course. CourseCourse selection indications . Course completion summaryOn rechargerChangeable course halfway throughOn rechargerOn shaverTime required (guide) [In the low temperature]cleandrychargecleandrychargeBacklight .Charge*.....Blinks1 hour .Clean/Dry/Charge..Blinks2 hours [+30 min] .Clean/Dry..–1 hour [+30min ] .Dry/Charge....Blinks2 h 40 min .Dry....–1 h 40 min• Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent. *The lamp goes out in 6 seconds. Cleaning with the self-cleaning recharger (continued) English .Do the following if the status lamp blinks or glows during the “Clean/Dry/Charge” course or the “Clean/Dry” course. BlinksCorrectly set the detergent cartridge and then restart a course. If the status lamp goes outContinue a course. GlowsRemove the shaver from the self-cleaning recharger and then check that the [CLEAN] lamp has gone out. (Be careful as the blade may be hot or wet.) Check that the water tank is correctly attached, the water tank cap is securely closed and the self- cleaning recharger is placed horizontally. When an abnormality has been correctedPress and hold [SELECT] for approximate...