7) Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it. To insert the new system outer foil, press down until it snaps into place. Replacing the inner blades (see fig. 8) Squeeze the foil frame release buttons and lift the toil frame upward to remove it. Remove the inner blades, one at a time, by grasping them firmly at both ends and pulling straight away from the shaver. To insert the new inner blades, hold the blades, one at a time, at both ends and press downward until they snap into place. ATTENTION: A nickel cadmium battery (s) that is recyclable powers the product you have purchased. At the end of it's useful life, under various state and local laws, it is illegal to dispose of this battery (s) into your municipal waste stream. Please call 1-800-8-BATTERY for information on how to recycle this battery (s). How to remove the built-in rechargeable battery (s) before disposal of the shaver (see fig. 9) The battery (s) in this shaver is not intended to be replaced by consumers. However, the battery (s) may be replaced at an authorized service center.The procedure described below is intended only for removal of the rechargeable battery (s) for the purpose of proper disposal. 1. Remove the two screws (a). 2. Pull the chassis (b) out of the housing. 3. Turn the chassis over and remove the battery (s) (c). WARNING: Do not attempt to replace the battery (s) tor the purpose of reusing the shaver. This could result in the risk of fire or electric shock. Caution * Do not charge the shaver where the temperature is below 0°C (32°F) or above 40°C (104°F), where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture. * Use only the included shaver charging adaptor RE3-89 to charge the ES8023/ES8024 shaver. * The supply cord of the charging adaptor cannot be replaced; if the cord is damaged, the entire charger should be discarded. * Dry the shaver completely before setting it in the charging adaptor. * Keep the charging adaptor away from water and handle it only with dry hands. Do not use an extension cord to connect the charging adaptor to an outlet. * The shaver may not immediately begin to charge after being placed into the charging adaptor after use. Allow the shaver to sit in the charging adaptor for a few minutes and check again to make sure that it is being charged. 9 • Do not place any metal objects like coins and paper clips on the charging adaptor as they will become warm. • Grip the plug when disconnecting the charging adaptor from a receptacle; tugging on the cord may damage it. • Store the charging adaptor and its cord set in a dry area where it will be protected from damage. • The outer foil is very thin. If handled improperly, it can be easily damaged. To avoid personal injury, do not use the shaver if it has a damaged foil or inner blade. • Wash the shaver in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for toilets, bathrooms or kitchen appliances. Do not submerge the shaver for a long time. • Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water. - Do not take the housing apart as this can affect the watertight construction. ♦ To prevent damage to the shaver housing, do not leave the shaver where the temperature may be extremely hot or, where it will be exposed to direct sunlight or a heat source. Specifications Power source: 100-120V AC, 50-60 Hz Motor voltage: 2.4 V DC Charging time: 1 Hour This product is intended for household use only. READ ALL INSTRUCTIONS BEFORE USE. FORYOUR CONVENIENCE, WE HAVE ESTABLISHED ATOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1 -800-338*0552. FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED ON THE BACK PAGE. 10 INSTRUCTIONS DE SÉCURITÉ IMPORTANTES Lors de I utilisation d un appareil compris les points suivants: électrique, les précautions de base Lisez toutes les instructions avant doivent toujours être respectées, y d'utiliser cet appareil. DANGER Afin de réduire tout risque de décharge 1. N’installez pas l’appareil dans des endroits où il peut tomber dans une baignoire ou un évier. 2. Ne touchez pas au chargeur s’il est tombé dans l'eau. Débranchez-le immédiatement. 3. Ne placez pas ou ne rangez pas te chargeur dans des endroits où il peut tomber dans une baignoire ou un évier. Ne le mettez pas ou ne le faites pas tomber dans l’eau ou un autre liquide. MISE EN GARDE 1. N’utilisez pas ce rasoir avec des lames de rasage et/ou une grille endommagée, car des blessures du visage risquent de se produire. 2. Une surveillance est nécessaire lorsque ce rasoir est utilisé sur des enfants, ou en présence d'enfants ou d’invalides. 3. Utilisez cet appareil uniquement pour l’usage pour lequel il est destiné tel que décrit dans ce mode d'emploi. N’utilisez pas des accessoires qui ne sont pas r...