Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
This position makes the trimmer an intercept cutter, cutting long hairs while the outer foil shaves shorter hairs. Make sure that the trirr mer is facing outward away from th^ neck. Trimming sideburns (see fig. 5) Slide the trimmer switch up to the 2n: position. Place the trimmer at a right angle t<: your skin and move it downward t<: trim sideburns. Cleaning your shaver (see fig. 6) For cleanliness and convenience, wc recommend that you clean you shaver with water and a liquid ham: soap. Regular cleaning will keep you shaver in good condition while preventing odors or bacteria from devel oping, and maintain the cutting per formance. With the outer foil in place, appl. some hand soap onto the outer foil Turn the shaver on and pour some water over the outer foil. After about 10-20 seconds, turn the shaver off. Remove the outer foil and clean i with running water. Wipe off any moisture from the shaver with a dry cloth and remove the protective cap to allow the oute foil to dry completely. Replacing shaving head components It is recommended that you replace the outer foil at least every year anc the inner blade at least every twc years to maintain your shaver’s cut ting performance. 7 Replacing the outer foil (see fig. 7) Squeeze the outer foil release buttons and lift the outer foil upward to remove it. To insert the new outer foil, press down until it snaps into place. Replacing the inner blades (see fig. 8) Squeeze the foil frame release buttons and lift the foil frame upward to remove it. Remove the inner blades, one at a time, by grasping them firmly at both ends and pulling straight away from the shaver. To insert the new inner blades, hold the blades, one at a time, at both ends and press downward until they snap into place. How to remove the built-in rechargeable battery (see fig. 9) The procedure described below is in* tended only for removal of the rechargeable battery for the purpose of proper disposal. WARNING: Do not attempt to replace the built-in, rechargeable battery yourself for the purpose of reusing the shaver. This could result in the risk of fire or electric shock. Please contact your nearest authorized Panasonic service center. 1. Remove two screws (a) and bottom cover (b). 2. Push the chassis out of the housing. 3. Remove the battery from the chassis. Caution • Do not charge the shaver where the temperature is below 0°C (32°F) or above 40°C (104°F), where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture. • Use only the included shaver charging adaptor RE3-82 to charge the ES4001 shaver. • The supply cord of the charging adaptor cannot be replaced; if the cord is damaged, the entire charger should be discarded. • Dry the shaver completely before setting it in the charging adaptor. • Keep the charging adaptor away from water and handle it only with dry hands. Do not use an extension cord to connect the charging adaptor to an outlet. • The shaver may not immediately begin to charge after being placed into the charging adaptor after use. Allow the shaver to sit in the charg- ATTENTION: The product you have purchased is powered by a nickel cadmium battery which is recyclable. At the end of it’s useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. Please call 1-800-8-BAT-TERY for information on how to recycle this battery. 8 ing adaptor for a few minutes and check again to make sure that it is being charged. • Do not place any metal objects like coins and paperclips on the charging adaptor as they will become warm. • Grip the plug when disconnecting the charging adaptor from a receptacle; tugging on the cord may damage it. • Store the charging adaptor and its cord set in a dry area where it will be protected from damage. • The outer foil is very thin. If handled improperly, it can be easily damaged.To avoid personal injury, do not use the shaver if it has a damaged foil or inner blade. • Wash the shaver in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for toilets, bathrooms or kitchen appliances. Do not submerge the shaver for a long time. • Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water. • Do not take the housing apart as this can affect the watertight construction. Specifications Power source: 100-120/220-240V AC, 50-60 Hz (Automatic voltage conversion) Motor voltage: 1.2 V DC Charging time: 8 Hours This product is intended for household use only. READ ALL INSTRUCTIONS BEFORE USE. Service-Assistance-Accessories 800-338-0552 panasonic.com/personalcare 9 IMPORTANTE PARA SU SEGURIDAD Al usar un aparato eléctrico, siempre se debe tomar ciertas precausiones básicas, incluyen- do las siguientes: Lea todas Jas instrucciones antes de usar este aparato. PELIGRO 1. No intente la unidad donde pueda caer e...