Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
a Warning! People with sensitive skin or allergies to cosmetics or similar conditions who suffer sudden skin irritations in reaction to shaving should first try the shaver on a small place on an arm or leg as a test. a To avoid injury, never use the shaver if it has a damaged foil or cutter. a Never allow the shaver to be immersed in water for long periods. a Never use shaving cream. It could cause the inner cutter to stick. a Only use shaving foam or soap lather. a Clean the shaver under running water. a Do not use salty water, cleaning agents or hot water. a Do not dismantle the shaver body as this can lead to an ineffective watertight seal. a If the shaver does not work properly, have it examined at an authorised service centre. a Use the shaver only for the purposes described above. Before using for the first time This wet/dry lady shaver can be used with shaving foam as a wet shaver or a dry shaver. It is also intended for use in the shower. Tests have shown that better results are achieved with warm water and shaving foam. 4 The shaver is perfect for use in the shower. Try using it as a wet shaver with shaving foam for about 3 weeks and experience the difference compared to dry shaving. Cleaning is child's play. Just rinse the shaving head under running water. It's that easy. Description of components © Protective cap © Housing for outer foil © Outer foil @ Outer cutter/long hair trimmer © Guide © Inner cutter © Inner cutter support block © Shaving head release button © On/Off switch ® Continuous operation switch © Battery compartment lid Changing the batteries Change the batteries when required without delay (see Figs. © to $)• If the cutter motion becomes slower, it is time to change the batteries. Never use the shaver if the batteries are weak. 1) Remove the battery compartment lid @ (see ©). 2) After checking the correct polarity, insert two AA batteries (see <&). 3) Refit the battery compartment lid again (see ©). You should remove the batteries if the shaver is to remain unused for a long period. 5 Using the shaver - Apply a generous amount of shaving foam to your skin. - Take off the protective cap © and switch on the shaver®. - You will obtain the best results if you move the shaver up and down keeping the shaving head flat against your skin so that the foil and cutters are able to work effectively at the same time. If necessary, trim long hairs with the trimmer® before shaving. Maintenance/cleaning Press the release button ® to release the shaving head and take off the housing. Switch on the shaver and rinse the inner cutter under running water. DO NOT USE HOT WATER! Then switch off the shaver, close the housing and dry carefully. When the shaving head is dry, replace the protective cover®. 6 Statement of conformity We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations: EC low voltage regulations, Electromagnetic compatibility, Applicable harmonised standards. Type/Description: Wet and dry lady shaver KH 228 Bochum, 31.10.2002 Hans Kompernaß - Managing Director 7...