Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
¦ Use moderate to slow, circular stroking movement. ¦ The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line. ¦ Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads. **Remington recommends that you use your new shaver daily for up to four weeks to allow time for your hair and skin to become accustomed to the new shaving system** Trim 1.Pulltrimmerreleasebuttontoengagetrimmer.(DiagramF) 2.Trimlong,difficulthairsandsideburns.(DiagramG) 3.Closetrimmerbypressingdown.(DiagramH) FGH 7 36291_R-41-51-7130 IB.indd 6-7 5/21/08 4:37:03 PM 8 9 The shaver is a washable appliance. The head assembly part may be cleaned under warm water. Cleaning & Care Daily: 1. Press the release button on front of shaver and open head assembly. (Diagram I) 2. Tap out excess hair shavings. (Diagram J) 3. Rinse the head of the shaver in running water. (Diagram K) NEVER submerge the shaver in water! 4. Close head assembly. (Diagram L) I J K L M N O P Q R When your rechargeable shaver reaches the end of its useful life, the Ni-MH batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. If this is not required by law, you may elect to dispose of the shaver with the batteries. CAUTION! Do not put in fire or mutilate your batteries when disposing as they may burst and release toxic materials. Do not short circuit as it may cause burns. Dispose of properly in accordance with your local and state requirements. To Remove the Rechargeable Battery: 1. Unplug the shaver. 2. Run shaver until motor stops. 3. Remove head from shaver (Press release button and pull head straight away from shaver body) 4. Using a small screwdriver pry front cover from shaver body. 5. Remove four screws located on front of shaver. 6. Remove rear cover from inner housing to expose batteries. 7. Pry batteries free from circuit board and cut wires. 8. Dispose of batteries. Battery Removal NOTE: **When cleaning your shaver, make sure the shaver is turned off and disconnected from the power cord.** CAUTION! ¦ To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals. ¦ To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver. ¦ The shaver should not be used until it has dried. Monthly: 1. Perform the daily cleaning steps 1 and 2. 2. Place a drop of liquid soap on the inside near each cutter. (Diagram M) 3. Brush the soap around vigorously with the supplied cleaning brush. (Diagram N) 4. Rinse soap out thoroughly. (Diagram K) 5. Lubricate each cutter with household oil. 6. Grasp plastic case around outer cutter and rotate toward the small dot on the shaver head. (Diagram O) 7. Pull outer cutter up and off of the head assembly and remove inner cutter. Repeat for the remaining cutters. (Diagram P) 8. Brush hairs from inner and outer cu...
Эта инструкция также подходит к моделям:Электробритвы - FLEX360 R-4130 (1.42 mb)
Электробритвы - FLEX360 R-5130 (1.42 mb)
Электробритвы - FLEX360 R-7130 (1.42 mb)
Электробритвы - FLEX360 R-4135 (1.42 mb)