Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
For best results the oven should be cleaned after each use as food deposits will dry or bake on when the oven is used again. Never use an abrasive such as wire wool, or scouring powder. The following can be used depending on the degree of soilage: 1. A damp cloth and mild detergent. 2. Cream cleaners such as “Jif” and a cloth or nylon scourer such as “Scotch brite”. 3. Oven cleaners such as “Ovenpad” or “Kleenoff”. Do follow the manufacturers instructions on the cleaning materials you use carefully. For cleaning of painted surfaces, glass, plastic and catalytic liners use mild detergents only. Removal of the oven door For thorough cleaning the oven door should be removed. Proceed as follows: 1. Open the door and unlock safety catches on both sides of the door. Using a coin (fig. 12) give the locks holding the catches a quarter turn (90 degrees) in clockwise direction. 2. Close the door approximately halfway to the stop position. 3. Press the door slightly forward and lift off. Do not lift door by the handle. 4. To replace the door, reverse this sequence. Remember to lock the safety catches by returning them to their original position (quarter turn anti-clockwise). Oven interior light During cleaning, the oven interior can be illuminated. To switch on the oven light turn the cooking method selector to the symbol £>;-. Fat filter The fat filter should be cleaned after use. Hold the filter by the handle and lift upwards. Boil the fat filter in hot water with some automatic washing powder added. See page 7 for details on how to insert the fat filter. 14 Cleaning and maintenance Removing the shelf supports To remove the rear panel The rear panel (fig. 10) of the oven can be 3. Re-assemble in reverse order. removed for cleaning. Proceed as follows: when replacing the rear panel, make sure that 1. Unscrew the four nuts. it is correctly placed. 2. Clean the panel as in the case of all enamelled surfaces. To remove the fan Having removed the rear panel you will gain fan. Clean the fan with hot soapy water, access to the fan (fig. 11) which is held on the Replace the fan and remember to fasten the motor shaft by a nut (left-hand thread). Loosen nut by turning it anti-clockwise, this nut by turning it clockwise and remove the Optional extras Optional catalytic set KS 9 E-No. 611 899 405 Baking sheets E-No. 611 899 359 An optional catalytic set is available consisting of two side panels and one rear panel which replaces the existing one. The two catalytic side panels are fastened (as illustrated) behind the shelf supports with two nuts each side. Make sure that the catalytic coating faces the interior of the oven. These liners help to keep the oven cleaner as they clean themselves to a great extent during roasting and baking at temperatures above 200 °C. As cleaning may be improved by exposure to a higher temperature it may be necessary to run the oven at 250 °C for 1 or 2 hours per week. Before carrying out such a heat cycle ...
Эта инструкция также подходит к моделям:Электрические печи - B 60 D (1016.49 kb)
Электрические печи - B 60 D (1016.49 kb)
Электрические печи - B 60 D (1016.49 kb)
Электрические печи - B 60 D (1016.49 kb)