Оценок - 5, средний балл: 4.2 ( )

Производитель: Cres Cor Размер: 980.21 kb Название файла: Язык инструкции:

NOTE: Do NOT change the mode of the controls (probe or timed) while oven is operating in a Cook/Retherm cycle. Oven must be in the HOLD cycle to change the timer or probe operation. 5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • Ovens Humidity with Microprocessor Controls FL-2267 Rev. 8 (1/05) Page 6 of 13 OPERATING INSTRUCTIONS, continued HOW TO OPERATE WITH FOOD, continued HOW TO SET HOLD-ONLY MODE: 1. Push power switch to “ON”. 2. Press the STOP button and oven will switch to HOLD cycle. 3. Press the HOLD button and set the desired hold temperature. NOTES: Cold food is NOT to be added when unit is operating in HOLD mode. For HOLD mode, preheat unit to 180°F/82°C for 60 minutes. HOW TO SHUT DOWN OVEN: Push switch to “OFF”. CAUTION: Ventilating fans will continue to run until the cabinet is cool. Do NOT disconnect the power supply to the cabinet while the ventilating fan is still operating. HOW TO OPERATE WITH HUMIDITY: Air is VERY HOT when door is opened. .. Humidity control is on the right of the control panel. See Figure 1 .. Humidity may be used in all control modes. .. Turn control knob to extreme counterclockwise position when humidity is not needed. .. Make sure there is water in the water pan. HOW TO PROOF: 1. Fill the water pan with three (3) gallons of HOT water. 2. Set the humidity control at low to midrange. 3. Set the Hold control to Nominal 120°F/49°C. 4. Preheat the oven at this setting for . hour. 5. Put in product. DO NOT use frozen product. Listed below are typical thermostat settings. Experiment with different settings to get the temperature and humidity you need. TEMPERATURE / HUMIDITY SETTINGS HOLD Dial Setting HUMIDITY Dial Setting Temp., °F/°C 1 2 3 4 5 6 7 8 9 10 140/60 15 20 25 35 50 65 85 100 100 100 150/66 10 15 20 25 35 55 70 100 100 100 160/71 5 10 15 20 30 40 60 80 100 100 180/82 5 5 10 15 20 25 30 50 70 95 200/93 5 5 5 10 15 20 25 35 50 75 NOTES: Values listed are % Relative Humidity. 5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • Ovens Humidity with Microprocessor Controls FL-2267 Rev. 8 (1/05) Page 7 of 13 MAINTENANCE INSTRUCTIONS HOW TO CLEAN THE UNIT: MAINTENANCE: WATER PAN Drain, wipe and fill water pan daily. (Clear vinyl drain-hose is provided). 1. Push hose onto drain nozzle under the base. 2. Turn knob to open the drain. To fully Dry Out: 1. Drain until 1/8” of water is left in pan bottom. 2. Turn humidity Thermostat to “High” until water is gone. 3. Wipe out pan. Delime or descale water pan parts as required, to prevent damaging build-up. WARRANTY COVERAGE MAY BE AFFECTED WITHOUT PROPER CLEANING. Cleaning Hints: 1. Use the mildest cleaning procedure that will do the job. 2. Always rub in the direction of polish lines to avoid scratching the surface. MAINTENANCE: CABINET 1. Wipe the inside of cabinet after daily use. 2. Leave doors slightly open to fully dry interior. ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: