Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Total max amps 3.8. - Optional -208/60/1, 50/60/1 or 3 phase. Supply must be wired to junction box with terminal block located at rear. Total max amps 2.6. - If using Flex-Hose, the I.D. should not be smaller than 3/4” and must comply with ANSI Z 21.69 - If casters are used with flex hose, a restraining device should be used to eliminate undue strain on the flex hose - For installation on combustible floors (with 6” high legs) and adjacent to combustible walls, allow 6” clearance. - Recommended - Install under vented hood - Check local codes for fire, installation and sanitary regulations. - If the unit is connected directly to the outside flue, an A.G.A approved down draft diverter must be installed at the flue outlet of the oven. NOTICE: Southbend has a policy of continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. OPTIONS AND ACCESSORIES - 6” legs in lieu of casters at no charge - 10” flue riser (back shelf not compatible with 10” flue riser) - 3/4” quick disconnect with flexible hose complies with ANSI Z 21.69 (specify 3’, 4’, 5’) - Tray or Tubular style lift-off shelving - Flame failure on open tops (not available on griddle combinations) - CM-36 Cheesemelter - NFR-36 Infrared Salamander Broiler - Standing pilot available in lieu of electronic ignition at no charge - Extra Oven Racks INTENDED FOR COMMERCIAL USE ONLY. NOT FOR HOUSEHOLD USE. 536 Rev 2 (June/2009) ...
Эта инструкция также подходит к моделям:Электрические печи - 536A (375.14 kb)
Электрические печи - 536A (375.14 kb)
Электрические печи - 536D (375.14 kb)