Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
1038599 Ves, you can: SAVE THESE INSTRUCTIONS NOTE: Check all parts for shipping damage before using. In case of damage, DO NOT use the equipment. Contact the Dealer/Carrier for further instructions. Safety Summary The following recommendations are made for the safe installation of the Wheel Lock Extension Handle Kit: A WARNING DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner’s manuals, service manuals or instruction sheets supplied with this product or optional equipment. If you are unable to understand the warnings, cautions or instructions, contact a healthcare professional, dealer or technical personnel before attempting to use this equipment - otherwise, injury or damage may occur. Any worn or damaged hardware must be replaced. After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. A ACCESSORIES WARNING Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. NOTE: If installing this kit on a wheelchair manufactured prior to 5/93, a new style wheel lock handle may need to be ordered. Contact an Invacare Dealer or Customer Service at the number on the bottom of this instruction sheet. Installing The Wheel Lock Extension Handle NOTE: Wheel lock extension handles cannot be installed on high mount wheel locks already equipped with extension handles. 1. Remove and discard the existing rubber tip on the wheel lock handle (if applicable). 2. Remove the button screw, washer and locknut that secures the existing handle to the wheel lock assembly. 3. Attach the looped end of the elastic cord of the wheel lock extension handle over the spacer of the existing handle. 4. Reassemble the existing handle to the wheel lock with the button screw, washer and locknut to secure the cord around the spacer. Tighten securely. NOTE: Cord is made of stretchable material and may be adjusted to a light or loose fit to meet the needs of the user. 5. Slide wheel lock extension handle over existing handle. (For more information regarding Invacare products, parts, and services, please visit J Part No 1039644 1 Wheel Lock Extension Handle FIGURE 1 Installing The Wheel Lock Extension Handle Invacare Corporation Yes, you can: USA One Invacare Way Elyria, Ohio USA 44036-2125 For Customer Service, call 800-333-6900 Canada 570 Matheson Blvd E Unit 8 Mississauga Ontario L4Z 4G4 Canada 800-668-5324 All rights reserved. Trademarks are identified by the symbols ™ and ®. All trademarks are owned by or licensed to Invacare Corporation or its subsidiaries unless otherwise noted. ©2009 Invacare Corporation Part No I039644 Rev D - 7/09 D 1039644...