Войти:
Оценок - 5, средний балл: 3.8 ( )

Инструкция по эксплуатации Schwinn Motor Scooters, модель 50SP06RD

Производитель: Schwinn Motor Scooters
Размер: 1.49 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


• OFF : Move the switch to the OFF position to shut down power to the electrical system. Use this feature only when other attempts to stop the scooter have failed. For example, if the throttle is stuck or malfunctioning, or if the scooter falls over. • ELECTRIC STARTER BUTTON : With one brake lever pulled, press the starter button to start the scooter with battery power. Refer to “Starting the Scooter”, pages 8 and 9 for detailed instructions. NOTE: The scooter can also be started with the kick starter. Refer to “Starting the Scooter” on pages 8 and 9 for instructions. HEADLIGHT AND TURN SIGNAL (LEFT HANDLEBAR) • For safety and increased visibility, the headlight is always on when operating the scooter. Use the low beam whenever there is oncoming traffic. • LOW BEAM : Use the low beam when traveling in traffic and during the day. • HIGH BEAM : Use the high beam to see further at night. Do not use the high beam when traveling behind another vehicle or if there is oncoming traffic. • TURN SIGNAL : Push the switch to the LEFT when turning left, and push the switch to the RIGHT when turning right. The center position is OFF. AUTOMATIC TRANSMISSION • Your new scooter has an automatic transmission that does not require the use of a clutch or gear shift. Description of Features, continued CELL PHONE INDICATOR • When you recieve an incoming call on your cell phone, the cell phone indicator light will flash. WARNING • NEVER use your cell phone while driving the scooter. • ALWAYS pull off the road to a designated parking area to use your cell phone. THROTTLE (RIGHT HANDLEBAR GRIP) • ACCELERATE: Twist the throttle toward you. • DECELERATE: Twist the throttle away from you or loosen your grip and the throttle will automatically return to the idle position. BRAKES • FRONT BRAKE LEVER: The FRONT brake lever is attached to the RIGHT handlebar. • REAR BRAKE LEVER: The REAR brake lever is attached to the LEFT handlebar. • For more information about using the brakes, see “Riding the Scooter”, page 10. To adjust brakes, see “Front and Rear Brake Adjustment” on page 12. KICK STARTER • Use the kick starter to start the scooter or prime the engine in the following situations: -If the scooter has been driven less than 100 miles (160 kilometers). -In cold or wet weather. -If the fuel tank has run completely dry (and more fuel has been added). -If the scooter has been stored for more than two weeks. -If the scooter fails to start using the electric starter button. -If the battery is discharged. • The kick starter can be used to “prime” the fuel system prior to using the electric start button. See “Starting the Scooter”, pages 8 and 9 for detailed instructions on using the kick starter. CENTER STAND • Always use the center stand on level ground. • To extend the center stand and park the scooter, grasp the left handlebar grip and the luggage rack with your right hand. Place your right foot on the foot peg of the center stand and push straight down. The rear wheel will raise slightly as the scooter comes to rest on the center stand. • To retract the center stand, grasp both handlebar grips and push the scooter forward. NOTE: Be sure your feet and legs are clear of the center stand. The center stand has a strong spring and will retract under the scooter very quickly. LUGGAGE RACK WARNING • Maximum load for the luggage rack is 10 lbs. (4.5 kg). NEVER exceed maximum load capacity for the scooter. Combined weight of the rider, gear and any accessories must never exceed maximum load capacity of 225 lbs. (102 kg). Overloading can impair the stability and performance of the scooter, possibly causing an accident. • Evenly distribute the load on the luggage rack and secure with straps. • Do not attach anything to the handlebars, fenders or footrests. VIN BADGE AND ACCESS PLATE • You will need your Vehicle Identification Number when registering your scooter with your local government or contacting your dealer. The VIN appears in two places: on the VIN badge, located on the back side of the front fairing, and under the VIN access plate. Before Every Ride For your safety and to keep the scooter in good working order, ALWAYS perform the following checklist before every ride. If you find any damaged or worn parts, DO NOT use the scooter. Contact your dealer for repairs. CHECK THE FUEL LEVEL • Check the fuel gauge. Add fuel if necessary. CHECK THE BRAKES • Apply the front and rear brakes to make sure they are working correctly. Refer to “Front and Rear Brake Adjustment” on page 12. CHECK THE TURN SIGNALS, BRAKE LIGHTS AND HORN • Turn the ignition key to the ON position to provide power to the scooter. Move the turn signal to the LEFT and RIGHT positions and make sure turn the signal lights and the turn indicator lights on the speedometer are functioning properly. • Apply the front brake and make sure the brake light is functioning properly. Repeat this test for the rear brake. • Push the horn button to make sure horn is functioning properly. CHECK T...

Эта инструкция также подходит к моделям:
Инвалидные коляски - 50SP06BK (1.49 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории