Войти:
Оценок - 2, средний балл: 4 ( )

Инструкция по эксплуатации Schwinn Motor Scooters, модель 50CG06SV

Производитель: Schwinn Motor Scooters
Размер: 1.5 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


-If the scooter has been stored for more than two weeks. -If the scooter fails to start using the electric starter button. -If the battery is discharged. ELECTRIC START • Retract the center stand and sit on the seat with both feet on ground. • Place the key in the ignition and turn it to the ON position. • Move the engine stop switch to the ON position. NOTE: The scooter will not start when the engine stop switch is in the OFF position. • Pull either brake lever. NOTE: The scooter will not start unless one brake is applied while starting. • Press the electric starter button for no more than five (5) seconds until the engine starts. Release the button as soon as the engine starts. NOTE: DO NOT press the electric starter button continuously for more than five seconds. Damage to the starter could occur. • If engine doesn’t start, wait ten (10) seconds and repeat the starting procedure. • If repeated attempts fail, use the kick starter to start the scooter or prime the engine. See “Kick Start” section above. • When the engine starts, apply enough throttle to idle the engine for 20 to 30 seconds. NOTE: DO NOT open the throttle while starting. Open the throttle only after the engine has started. • NOTE: To prolong engine life, allow the engine to reach normal operating temperature before driving. This usually takes about 2 to 3 minutes. Breaking In the Scooter • For the first 100 miles (160 kilometers) it is recommended that you kick start the scooter, or use the kick starter to “prime” the engine (force fuel into the carburetor) prior to using the electric starter. This preserves battery life and reduces wear to the electric starter during the break-in period. • ALWAYS allow the engine to warm up for 2 to 3 minutes before driving. • Do not drive the scooter at a constant speed for long periods of time during the break-in period. Avoid overheating the engine. Riding the Scooter ENTERING ROADWAYS • Apply the turn signal if needed. • Make sure there is no oncoming traffic. ALWAYS be aware of other vehicles on public roads. Many accidents are caused when drivers of cars do not see scooters who share the road. • Release the brake and gradually advance the throttle for smooth acceleration. ACCELERATION AND DECELERATION • Adjust speed by twisting the throttle. Twist the throttle toward you to accelerate. Twist the throttle away from you to decelerate. NOTE: Your new scooter has an automatic transmission, so there is no clutch and no need to shift gears. • ALWAYS allow the engine to warm up thoroughly before hard acceleration, or damage to the engine could occur. BRAKING WARNING • ALWAYS apply the front and rear brakes simultaneously to slow down or come to a stop. • BE CAUTIOUS when using the front brake. Loss of front wheel traction can make both steering and braking ineffective. Using the front brake on loose gravel or wet road conditions can result in loss of traction. • DO NOT continually engage the brakes for an extended period of time. This causes excessive wear and can overheat the brakes, causing brake failure which could result in serious injury or death. • In wet driving conditions, be aware that normal stopping distances are increased. PARKING NOTE: Always park on smooth, level ground. • Turn the ignition key to the OFF position. Remove the key. • Move the engine stop switch to the OFF position. • Dismount the scooter and engage the center stand. • DO NOT park on a slope or on soft surfaces. The scooter could tip over. • DO NOT park near flammable materials. • Engage the steering lock to prevent theft (see instructions on page 6). Routine Care and Maintenance WARNING • When performing routine maintenance on the scooter, NEVER start or run the engine in an enclosed area, even if the doors and/or windows are open. ALWAYS start and operate the scooter outdoors. • Allow the engine, muffler and other hot parts to cool before touching. • Conduct cleaning and maintenance using the center stand (see page 7) on a smooth, flat, hard surface. WARNING GASOLINE AND ITS VAPORS ARE EXTREMELY FLAMMABLE AND EXPLOSIVE AND CAN CAUSE SEVERE BURNS OR DEATH. • Keep gasoline away from open flames, sparks, pilot lights or other sources of ignition. • NEVER smoke while refueling the scooter. • Fill fuel tank outdoors or in a well-ventilated area. • If fuel spills, DO NOT start engine until the spilled fuel has evaporated and vapors have dissipated. • Make sure the fuel lines, tank and cap do not have cracks or leaks. • NEVER start or operate the scooter near gasoline, paint thinner, or any other flammable liquids. Vapors could ignite causing a fire or explosion. • If you swallow gasoline, DO NOT INDUCE VOMITING. If you inhale gasoline vapor and feel ill, or spill gasoline into your eyes, see a physician immediately. • If you spill gasoline on your skin or clothing, change clothing and wash your skin with soap and water. REFUELING THIS SCOOTER HAS A 4-STROKE ENGINE AND REQUIRES UNLEADED 90 OCTANE OR HIGHER GASOLINE, WITHOUT METHANOL ...

Эта инструкция также подходит к моделям:
Инвалидные коляски - 50CG06RD (1.5 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории