Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
6. Speed Increase Button: Button: This This button Button Increases the maximum speed. 7. Joystick: This controls the speed and direction of the Powerchair. Push the joystick in the direction you want to go. The further you push it, the faster the speed will be. Releasing the joystick will automatically engage the brakes and stop the Powerchair. 8. Charging Port for Off-Board Charger: This is a secondary charging port, in addition to the charging port located on the battery pack. Only plug into this port with the qualified charger certified by the original manufacturer of the Powerchair. This port should not be used as a power supply for any other electrical devices. The behavior against the two states as above will void the warranty of the Powerchair. Note: The controller can be fitted to suit either right or left-handed users. 8 Figure 2 7 3 6 21 4 5 8/18/2004 9 Locking/Unlocking the VSI Joystick LOCK MODE: The VSI controller can be locked to prevent unauthorized use. The locking method is achieved through a sequence of key presses and joystick movements, as detailed below. To lock Powerchair controller: • While the controller is switched on, depress and hold the on/off button. • After 1 second the controller will bleep. Now release the on/off button. • Push the joystick forward until the controller bleeps. • Push the joystick in reverse until the controller bleeps. • Release the joystick, there will be a long bleep. • The Powerchair controller is now locked. To unlock the Powerchair controller: • Use the on/off button to switch the controller on. The maximum speed/profile indicator will be rippling up and down. • Push the joystick forward until the controller bleeps. • Push the joystick in reverse until the controller bleeps. • Release the joystick, there will be a long bleep. • The Powerchair is now unlocked. SLEEP MODE: If the controller is left on and not used for more than ten minutes, the controller will automatically “go to sleep”. This is recognized by a slow intermittent flash of the battery indicator lights. Simply turn the controller off and back on to reset. 8/18/2004 10 Drive/Freewheel Mechanism The drive/freewheel levers are found toward the front of the Powerchair, one on each side, located at the end of each motor. These levers will allow you to disengage the drive mechanism and push the Powerchair while in freewheel mode. Always leave the chair in drive mode. The freewheel option is there only to allow the chair to be pushed manually when the need arises (i.e., to store or push unit out of a tight space). The Powerchair will not function while the drive mechanism is disengaged. In addition, the VSI-50 will flash a fault code and beep steadily if turned on. Refer to Table 1 for more details. Freewheel Lever Drive Powerchair Push Powerchair Figure 3 8/18/2004 11 User Transferring You can transfer either forward, left or right from the chair. The armrests are hinged at the bottom and can be pushed down and out of the way for sideways transfer. Pull armrest up, then push armrest forward and down for side transfer. Reclining Seat The Jiffy Powerchair comes with a reclining seat. The reclining seat lever is located on the left side below the armrest. Simply pull the lever up to adjust. This feature also allows the seat to be folded (Refer to Figure 7 for picture of folded seat). 1) Pull Up 2) Push Forward & Down Figure 4 Figure 5 8/18/2004 12 Disassembling/Transporting the Shoprider Jiffy Powerchair Follow these simple guidelines for disassembly: 1. Park the Powerchair on a level surface 2. Ensure the wheels are locked in drive mode (Fig 3) 3. Fold up footplate 4. Unplug VSI from rear of unit 5. Remove battery pack from rear of unit 6. Remove seat by unscrewing the tightening knobs and lifting seat upward and off 2 3 4 5 6 Figure 6 1 2 3 4 5 6 Figure 7 8/18/2004 13 Driving Your Shoprider Jiffy Powerchair Ramps, Slopes and Cambers The Jiffy indoor/outdoor Powerchair has the ability to negotiate ramps, slopes and cambers of a low to medium gradient. It is of the utmost importance that the following points are observed: 1. Never attempt to go up or down an incline which has a rough, wet or slippery surface (loose gravel, tree roots, wet grass, polished floor, etc.) 2. Always approach an incline head on, not at an angle 3. Always travel at a speed that you are comfortable with and that you feel in complete control 4. Avoid sudden or erratic action with the joystick 5. When riding along in a straight line you may experience “veering to one side”. This is due to the natural camber in the construction of the pavement. To correct this you simply have to steer slightly against it, as you continue to move forward. 8/18/2004 14 Caring for Your Shoprider Jiffy Powerchair First Time Use Prior to using your Jiffy portable Powerchair for the first time, you must charge the batteries fully (refer to Battery Charging Procedures). Charging may take up to 8 hours. Charging the batteries completely prior to first ...
Эта инструкция также подходит к моделям:Инвалидные коляски - UL7WR-12 (502.57 kb)