Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
Use the arm rest for support if necessary. • Adjust the tiller and seat as previously described. Starting Scooter Movement • Ensure that you are seated in a comfortable position. • Turn the key to the on position. • Your speed setting should be on or near the turtle (slow). • Push your right thumb lever (yellow) and the scooter will move forward slowly. The harder you push, the faster the scooter goes but will only reach the speed level that has been selected. • Release the lever and the scooter will slowly come to a stop as the magnetic brake automatically engages. Steering Steering the scooter is light and easy. When starting off ensure that you give a wide clearance when turning so that the rear wheels clear any obstacle that you are passing. When steering through limited spaces such as a doorway or when turning around, turn the tiller handles where you want to go and apply power gently. The scooter will turn very tightly, but will still move with complete stability as long as the speed is not too high. Reversing Before reversing ensure that the area behind is free from any hazards or obstructions. Adjust your speed setting to a low setting before you move in reverse. Push your left thumb lever (black), and steer wide of all corners and obstacles. Dismounting Before dismounting ensure that the key is turned to the off position. Dismount the scooter by pushing the arm upward out of the way and sliding off the seat or swivel the seat around to dismount. Use the arm rest for support if necessary. CAUTION: Please ensure that care is exercised when mounting or dismounting the scooter and that the tiller and foot rest is not used for support. 5/11/2007 11 EXTRA GUIDELINES IN THE CONTROL OF YOUR SCOOTER Ramps The stability of your scooter is governed by several factors such as the seating position, the angle of the slope and your height and weight. When approaching an incline, do so directly and not at an angle and where ever possible avoid making turns. When going down a ramp or slope keep the speed settings to slow. This will ensure there is a safe controlled descent. When the thumb levers are released the scooter will slowly stop. Safe Climbing Angle Always follow the guidelines of the safe climbing angle as shown in figure 9. Caution -Do not turn off the control key while the unit is in motion Grass and Gravel Please follow the guidelines given previously and your scooter will perform admirably over many surfaces. Avoid long grass, loose gravel and sand. NOTE: You should not operate your scooter in wet weather or on wet surfaces. This may cause the motor to short out or cause other irreversible damage. NOTE: To preserve battery charge, your scooter may go into sleep mode after being idle for a few minutes. To remove from sleep mode, turn the key off and back on again. Figure 9 5/11/2007 12 TRANSPORT / STORAGE The Dasher Portable scooter is designed to be quickly and easily disassembled into sections for transportation and storage. Follow these simple guidelines for disassembly: Dasher 9 Disassembly (Fig 10 & 11) 1) Remove the front basket: Lift basket up and off. 2) Fold the seat down and remove: Pull yellow swivel seat lever up and lift seat up and off. 3) Remove battery pack: Lift battery pack up and off using handle (Note: battery pack is secured by Velcro). 4) Fold tiller down and lock into place: Loosen tiller adjustment knob, lower tiller, and tighten adjustment knob. Lock tiller assembly by pulling yellow lever up and to the right. 5) Detach rear section from front section: Detach lever (yellow) is located in the rear of the scooter next to the freewheel lever. Slide lever to “detach” and separate rear section from front section. 1 2 3 4 5 Figure 10 2 1 4 3 5 Figure 11 5/11/2007 13 BATTERIES AND BATTERY CHARGING The Shoprider® Dasher Portable scooter is supplied with maintenance-free, sealed lead acid batteries. For easy handling, the batteries are contained within a battery pack. Battery life and performance may be affected by temperature, terrain, condition of battery, the weight of the user, and care of batteries. The battery needle gauge is only a guide and is most effective when the scooter is moving, only then is the true discharge level displayed. • When the scooter stops the battery needle gauge may indicate full. • An active user can use up to 30% of battery capacity or more per day. • Inactive users may only use 50% of battery capacity in a week. • In both these instances the battery should be put on charge over night. Keeping the batteries charged will extend the life of the batteries Battery Charger The battery charger is a 3-amp off board. The Dasher Portable scooter has a built in charger port on the rear side of the battery pack. This special feature allows the batteries within the battery pack to be charged without the scooter. A compartment built into the battery pack is designed to store the battery charger when not in use. First Time Use Prior to using your Dasher Portable scooter ...