Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
To remove nozzle assembly (for purposes of storage, or clearing blockages): • Turn engine off and disconnect spark plug • Loosen hose clamp on the front plate with flathead screwdriver or 5/16 wrench • Slide hose off of front plate inlet • Bend one side of nozzle bracket inward and twist the assembly to remove the hook from the axle • Twist back and lift to remove the other side of nozzle bracket from the axle WARNING DANGER NEVER RUN OR OPERATE YOUR MACHINE UNLESS DISCHARGE BAG IS ATTACHED, AND THE INTAKE NOZZLE IS INSTALLED. B. Put Oil and Gasoline in Engine Before Starting WARNING DANGER HANDLE FUEL WITH CARE. IT IS HIGHLY FLAMMABLE. FUELING A HOT ENGINE OR NEAR AN IGNITION SOURCE CAN CAUSE A FIRE AND RESULT IN SERIOUS PERSONAL INJURY AND/ OR PROPERTY DAMAGE. 1. Little Wonder recommends using SAE 30 Oil. The use of multi-viscosity oil will result in high oil consumption and possible engine damage. 2. Add gasoline to the fuel tank, and you are ready to start. 3. See Engine Operating & Maintenance instructions for more detail description of type and amount of oil and gasoline used. C. Use of Lifting Lug Little Wonder High Performance Vac is supplied with convenient Lifting Lug that can be used when you need to move the unit. This Lug can hold weight up to a total of 250 lbs. Operation WARNING DANGER THE OPERATOR OF THIS HIGH PERFORMANCE VAC IS RESPONSIBLE FOR ACCIDENTS OR HAZARDS OCCURRING TO HIMSELF, OTHER PEOPLE OR THEIR PROPERTY. A. Start Engine WARNING DANGER DO NOT USE OR SERVICE THE UNIT WHEN IT’S SUSPENDED FROM THE LIFTING LUG. WARNING DANGER FUEL IS EXTREMELY FLAMMABLE. HANDLE IT WITH CARE. KEEP AWAY FROM IGNITION SOURCES. DO NOT SMOKE WHILE FUELING YOUR EQUIPMENT. 1. Open fuel valve. 2. Open choke. 3. Set throttle to run. 4. Pull starter rope 1 – 3 times. 5. Allow engine to turn over. 6. Close choke. 7. Set throttle speed to max - Always operate vacuum at full throttle. WARNING DANGER ENGINE EMITS CARBON MONOXIDE. DO NOT OPERATE OR REFUEL IN ENCLOSED AREA. B. Vacuuming 1. Adjust nozzle to desired height by turning the nozzle control knob, secure position with wing nut. 2. Vacuum debris from lawn or paved surfaces. Vacuum the following: leaves, small twigs and sticks, acorns, thistles, seed pods, grass clippings, straw, wood chips, dry mulch, litter, small cans & bottles, paper products, styrofoam products. 3. Avoid the following: excessively wet surfaces and debris, gravel surfaces, large hard objects, rocks, long fibrous materials (vines, rope, string etc). Do not force anything into vacuum. WARNING DANGER KEEP RECOIL STARTER SCREEN AND ENTIRE ENGINE CLEAR OF ALL DEBRIS. DO NOT OPERATE ENGINE WITH AN ACCUMULATION OF GRASS, DIRT, LEAVES OR OTHER COMBUSTIBLE MATERIAL NEAR MUFFLER. WARNING DANGER DO NOT OPERATE UNIT IF EXCESSIVE VIBRATION OCCURS; SHUT ENGINE OFF IMMEDIATELY! REMOVE SPARK PLUG WIRES AND CHECK FOR DAMAGED IMPELLER, LOOSE IMPELLER BOLT, LOOSE IMPELLER KEY, OR LODGED FOREIGN OBJECTS. C. Empty Debris Bag 1. Turn off engine and let it come to a complete stop before removing the debris bag. 2. Roll vacuum to the desired unloading location (compost pile, curb-side, wooded area, tarp, etc.). 3. Open clasp on band clamp to release bag to the ground. Avoid dragging bag on surface to prolong bag life. 4. Empty contents of debris bag (handle straps are provided on the under side of the bag for aid in dumping contents). 5. Reconnect bag to collector. D. Refueling the Engine 1. Stop engine and allow it to cool for a few minutes before refueling. Storage and Maintenance A. Storage 1. After each use, run HPV with the empty bag attached to help clear out any loose material in the housing. 2. When not in use store High Performance Vac in sheltered area (a dry place) not accessible to children. Keep throttle in the “Stop” position. 3. The High Performance Vac, as well as fuel, should not be stored in a house or poorly ventilated areas. 4. Do not store fuel in the engine’s gas tank longer then 30 days. B. Maintenance Area Every Use Every 5 Hrs After First 8 Hrs of Use Every 25 Hours Every 50 Hours *Engine See Engine Manual Check muffler area for accumulation of debris . Check for excessive vibration . Inspect for loose or damaged parts . Inspect for clean intake nozzle . Inspect labels condition . Check oil level . **Oil change . . Service air cleaner . Clean and inspect spark plus arrester . * See Engine Operating & Maintenance instructions for more detail maintenance and service schedule ** Change oil every 25 Hrs if operating under heavy load or high ambient temperature C. Removing Blockage in Moving Parts WARNING DANGER TURN OFF ENGINE BEFORE YOU DISCONNECT HOSE, AND MAKE SURE ALL MOVING PARTS COME TO A COMPLETE STOP. WARNING DANGER BE SURE THROTTLE IS IN “STOP” POSITION, AND FAN HAS COME TO A COMPLETE STOP. WARNING DANGER DISCONNECT THE SPARK PLUG WIRES BEFORE ANY CLEANING OR MAINTENANCE! WARNING DANGER WEAR GLOVES, THE CLOG MAY CONTAIN SHARP MATERIALS. 1. Support the housing with 2x4 lumber such t...
Эта инструкция также подходит к моделям:Газоноуборщики - 5601 (1.35 mb)