Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
If the collection bag becomes worn or damaged, replace. 1. Mains cables and extensions are available from your local Husqvarna Outdoor Products Approved Service Centre. 2. Only use extension cables specifically designed for outdoor use. AWARNING: If received assembled, ensure your unit is properly assembled and all fasteners are secure. Cables Assembly Instructions Vacuum Assembly How to convert unit from vacuum use to blower use Cable restraint 1 2 3 3 Starting and Stopping AWARNING: You MUST make sure the tubes are secure before using the unit. AWARNING: Do not use the unit without the tubes or collection bag properly attached to avoid flying debris and/or impeller contact which can cause serious injury. Always wear eye protection to prevent rocks or debris from being blown or ricocheting into the eyes and face which can result in blindness or serious injury. Operation Operating position Eye Protection Eye Protection Blower Vacuum Using your unit as a blower AWARNING: Inspect the area before using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation. Use your unit as a blower for: • Sweeping debris or grass clippings from driveways, sidewalks, patios, etc. • Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or between bricks. Direct air flow by directing the blower tube down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences. Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face. Be careful when working near plants. The force of the air could damage tender plants. Using your unit as a vacuum AWARNING: Do not vacuum stones, gravel, metal, broken glass, etc., to avoid severe damage to the impeller. To avoid the possibility of electrical shock, do not attempt to vacuum water or other liquids. Use your unit as a vacuum to pick up dry material such as leaves, grass, small twigs, and bits of paper. • Move slowly back and forth over the material as you vacuum. Avoid forcing the unit into a pile of debris as this can clog the unit. • Keep the vacuum tube about an inch above the ground for best results. AWARNING: If the unit becomes clogged, stop the unit and disconnect the mains electricity supply. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris. Maintenance AWARNING: Stop the unit and disconnect the mains electricity supply before performing maintenance. General recommendations The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjustments will need to be made periodically to properly maintain your unit. Before each use Check for loose fasteners and parts • Inlet Cover • Blower Tube • Vacuum Tubes • Collection Bag Check for damaged or worn parts Please contact your local Husqvarna Outdoor Products Approved Service Centre for further information or for replacement of damaged or worn parts. • ON/OFF Switch - Ensure switch functions properly by moving the switch to the OFF position. Make sure motor stops; then restart motor and continue. • Inlet Cover - Discontinue use of unit if inlet cover fails to latch properly or if it is damaged in any way. After each use Inspect and clean unit and labels Stop unit and disconnect the mains electricity supply. • After each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth with a mild detergent. • Wipe off unit with a clean dry cloth. AWARNING: All internal or electrical service MUST be performed by your local Husqvarna Outdoor Products Approved Service Centre. How to remove an object from the air intake AWARNING: Stop the unit and disconnect the mains electricity supply before opening the inlet cover. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. AWARNING: Perform the following steps after each use: • Stop the unit and disconnect the mains electricity supply. • Allow motor to cool before storing or transporting. • Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. • Store unit unplugged, well out of the reach of children. Seasonal storage Prepare unit for storage at the end of the season or if it will not be used for 30 days or more. If your blower is to be stored for a period of time: Clean collection bag IMPORTANT: THE COLLECTION BAG MUST BE PROPERLY EMPTIED. • You must properly empty and maintain the collection bag to avoid deterioration and obstruction of air flow. • Remove the coll...