Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
To remove the plastic trash bags when full: a. Disengage blades, shift into neutral, engage the parking brake and stop the engine. b. Unlatch and raise cover. c. Remove one container at a time by grasping container handles and pulling toward the rear, off of the tube rails. d. With the container resting on the ground, close and secure the top of the plastic lawn bag. e. Tip the container on its side and slide the filled bag from the container. f. Install a new plastic lawn bag with the edges of the bag draped over upper lip of the Container (for replacement bags refer to REPLACEMENT PARTS). g. Repeat for other containers. h. Reinstall containers making sure right container overlaps left container at center supports. i. Close cover and secure latches over center support tubes. • Avoid cutting wet grass or in the morning while the dew is still heavy. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging. • If the grass bagger fails to pick up cut grass or leaves, it is an indication that clogging has occurred in the system or that the grass bagger containers are full. a. Disengage blades, place motion control levers in neutral position, engage parking brake and stop engine. -Unlatch and raise cover. -Slide out containers and dispose of clippings. -Replace containers, close cover, and latch. b. Check for clogging. -Remove all debris in chute. -Reassemble chutes. CAUTION • DO NOT operate mower with grass bagger partially installed. • Disengage blades and stop engine before leaving mower seat to empty containers, unclogging chutes, etc. • Close cover before starting. • Disengage mower blades when crossing driveways or gravel surfaces and other areas where thrown objects could be a hazard. • DO NOT attempt to vacuum up cans or other potentially hazardous projectiles. CUSTOMER RESPONSIBILITIES GENERAL RECOMMENDATIONS Always observe safety rules when performing any maintenance. • Before each use check for loose fasteners. • Clean unit thoroughly after each use. BLADE CARE For best results mower blades must be kept sharp. Replace bent or damaged blades. • See BLADE CARE instructions in your mower operator’s manual. CAUTION BEFORE PERFORMING ANY MAINTENANCE, SERVICE OR ADJUSTMENTS: • Set parking brake. • Place motion control levers in “NEUTRAL” position. • Place clutch control in “DISENGAGED” position. • Turn ignition key to “OFF” position. • Make sure blades and all moving parts have completely stopped. • Disconnect spark plug wire(s) from spark plug(s) and place wire where it cannot come in contact with plug. STORAGE When grass bagger is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. Store in a clean, dry place. CAUTION Do not leave grass in bagger containers. Empty containers after each use and before storing. Failure to do so may result in spontaneous combustion which could develop into a fire. CAUTION Grass bagger components are subject to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary. PARTS 13 1 2 3 4 5 6 8 9 14 15 11 7 13 10 12 9 8 8 9 9 1 .. 532 124670 .... 1...RETAINER SPRING 2 .. 532 127533 .... 1...SCREEN, COVER 3 .. 539 108100 .... 1...GASKET, COVER 4 .. 532 130895 .... 1...LATCH. HANDLE, COVER 5 .. 532 132796 .... 1...SPRING COVER, LT 6 .. 532 132983 .... 1...SPRING COVER, RT 7 .. 532 133235 .... 1...SPACER, COVER 8 .. 539 976977 .... 8...NUT, 10-24 HEX W/NYLOC 9 .. 539 991034 .... 8... 10-24 x 5/8 WASHER HD ZD 10 .. 532 414173 .... 1... STRIP, REINFORCEMENT 11 .. 532 160274 .... 1... COVER TOP 12 .. 532 174083 .... 3...CAP PLUG TUBING END 13 .. 532 414172 .... 1... FRAME ASSEMBLY, 2-BIN 14 .. 532 192786 .... 1... PIN, HINGE PIVOT 15 .. 532 400226 .... 2...CONTAINER BAG SOFT ITEM P/N QTY. DESCRIPTION ITEM P/N QTY. DESCRIPTION PARTS 14 3 5 6 7 9 10 14 13 1 22 8 4 6 11 12 5 5 24 20 2 23 16 17 25 16 19 6 6 15 18 PARTS ITEM P/N QTY. DESCRIPTION ..539 131279 ....1...SUPPORT - BAGGER ..539 990134 ....4...HCS 3/8-16 x . GR 5 ZD ..539 976979 ....4...NUT 3/8-16 HEX NYLOC ZD ..539 131277 ....1...BRACKET, HANGER ..539 990208 ....6...RRSNB 5/16-18 X 1 GR 5 ZD ..539 990717 ..14...NUT 5/16-18 HEX NYLOC ZD .. 539 115938.....1...FLEX HOSE, 50" .. 539 131190.....1...UPPER CHUTE .. 539 115719.....1...HOSE CLAMP ..539 131282 ....1...SUPPORT STRAP, LEFT ..539 131284 ....1...SUPPORT STRAP, RIGHT ..539 121399 ....1...CAST WEIGHT ..539 131343 ....1...WEIGHT BOX ITEM P/N QTY. DESCRIPTION 14..539 990209....2...HCS 5/16-18 x 1 GR 5 ZD 15..539 990188....2...WASHER, 5/16, SAE 16..539 990316....6...RHSNB, 5/16 -18 X ., GR5 17 ..539 115243....1...BAFFLE 18 .. 539 116715.....1...DISCHARGE MOUNT BRCKT 19 ..539 115244....1...HI LIFT BLADE, 36", RIGHT 20 ..539 115245....1...HI LIFT BLADE, 36", LEFT 21 ..539 990580....2...HCS, . -20 X ., GR5 22 ..539 990055....2...WASHER, ., SAE 23 ....