Оценок - 5, средний балл: 4
(
)
)
|
Фрагмент инструкции
Familiarise yourself with the surroundings of your working area. Check for possible risks which might be not audible due to the noise of the machine. Please observe the prescribed local quiet times. When you interrupt work to move to another working area, always switch off your accu cylinder mower and remove the key from the socket. Do not operate your Cylinder Lawnmower near swimming pools or garden ponds. Never use the unit when it is raining or in damp or wet areas. Accu Security: Danger! Short-circuit – fire risk! V Contacts should never be bridged with metal! Danger of fire ! Never charge the Accu anywhere near acids and easily inflammable materials. Danger of explosion! Do not throw the used Accu into fire under any circumstances. Only charge the Accu with the charger supplied! Using other charging units could lead to damage and injury. Protect the Accu from excessive sunlight. Using a charger other than the GARDENA charger supplied releases GARDENA from all liability and warranty claims. Keep the charger in a dry place. Only charge the Accu in a dry place. Only use the Accu for the Rechargeable Cylinder Lawnmower. The mower cannot be started as long as the charger is plugged in! Protect the charging socket against dirt and moisture. The cylinder lawnmower may not be powered by any battery other than the one supplied for it. Under no circumstances use a battery that is not rechargeable. If the battery develops a leak, remove the safety key, put on gloves, remove the battery and dispose of it. GB 13 GB Do not touch battery acid. out immediately with water and send for a If acid comes in contact with the eyes, wash doctor. 3. Assembly Assembling the handle: 78 745B960AA1zm Fit Accu: 14 EFCD 1. Insert lower part of bottom upright 1 into upright holders 2 up to stop and secure with the screws 3. 2. Push connector 4 from underneath into upper part of bottom upright 1. 3. Insert threaded rod 6 from left through lower parts of central upright 5, upper part of bottom upright 1 and connector 4 right up to the stop. 4. Slide threaded bearing 8 into clamping lever 7. 5. Screw clamping lever 7 onto threaded rod 6 approx. 4 turns. 6. Move clamping lever 7 onto connector 4 and check whether clamping lever 7 locks. 7. If clamping lever 7 does not yet lock, screw another turn onto threaded rod 6. Repeat procedure until clamping lever 7 locks on connector 4. 8 Firmly attach bottom part of top upright 9 to upper parts of central upright 5 using 2 wing nuts z 126743 m. The safety starter lock B on the crossbar9 must then be on the left. 9. Fix the motor cable 0 to the upright with the two cable clips A. Warning! Short-circuit – fire risk ! AV Accu-contacts should never be bridged with metal! The Accu is supplied charged at the factory but may lose charge if it has been stored for a long time. Charge the Accu before using it for the first time (see 7. Maintenance Charging the Accu). 1. Press Accu cover C lightly at the front and open. 2. Insert the Accu D into...
Эта инструкция также подходит к моделям:Газонокосилки - ART 4026 380 AC (196.65 kb)
Газонокосилки - ART 4026 380 AC (196.65 kb)
Газонокосилки - ART 4026 380 AC (196.65 kb)
Газонокосилки - ART 4026 380 AC (196.65 kb)