Войти:
Оценок - 2, средний балл: 4.5 ( )

Инструкция по эксплуатации Cub Cadet, модель 11A-436F100

Производитель: Cub Cadet
Размер: 1.71 mb
Название файла: cd7c609d-1649-46bd-8770-5064cb445c19.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Lift the grass catcher up, and off of the pivot rod. Release the chute door. SECTION 6: CONTROLS Read this owner’s manual and safety rules before operating your lawn mower. Compare the illustrations in Figure 8 with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. The operation of any lawn mower can result in foreign objects being thrown into the operator’s eyes thus causing severe eye damage. Always wear safety glasses while operating the mower, or while performing any adjustments or repairs on it. 9 Recoil Starter The recoil starter is attached to the handle. Stand behind the unit and pull the recoil starter to start the unit. Primer The primer is used to pump gas into the carburetor. Use it to start a cold engine, but do not use it to restart a warm engine after short shutdown. Refer to engine manual for illustration. Blade Control Handle ▲—------------——“ The blade control handle is located on the upper handle of the mower. The blade control handle must be depressed in order to operate the unit. Release the blade control handle to stop the engine and the blade. Throttle Control The throttle control is used to regulate engine speed. It cannot be used to stop the engine. SECTION 7: OPERATION Gas And Oil Fill-Up Oil: • Only use high quality detergent oil rated with API service classification SF, SG or SH. Use SAE30 oil; do not use 10W40 oil. • Fill oil sump and check the oil level following steps below. a. Position the mower on level ground and clean area around oil fill plug. b. Remove oil fill plug and dipstick. Wipe dipstick clean, insert it into oil fill hole and tighten securely. c. Remove dipstick and check oil level. If the oil is not upto FULL mark on the dipstick, pour recommended oil through the oil fill and check the level again. • Install oil fill plug and dipstick, tighten securely. NOTE: Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, these multiviscosity oils will result in increased oil consumption when used above 32°F. Check the oil level more frequently to avoid possible engine damage from running low on oil. Gasoline A WARNING: Never fill fuel tank indoors, or when engine is running or hot. Do not smoke when filling up the fuel tank. • Clean area around fuel cap. Remove cap. Use a funnel to prevent spillage. • Pour approximately 1.5 quarts of fresh, regular grade, unleaded gasoline slowly to the fuel tank. IMPORTANT: Never mix engine oil with gasoline. • Fill tank to 1/2” below the bottom of the filler neck. Wipe any fuel spillage. Do not fill fuel tank completely. Provide space for fuel expansion. Starting Engine A WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower. 10 • To prevent the unit from sliding, place your foot firmly against the tire. • Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug wire is fastened securely over the metal tip on the spark plug. • Move throttle control to FAST position. • Push primer three times. Wait about two seconds between each push. In cold weather around 55° F or below, prime five times. Do not prime to restart a warm engine after a short shutdown. • Grasp starter handle and pull rope out slowly until engine reaches the start of compression cycle (rope will pull slightly harder at this point). Let the rope rewind slowly. Pull rope with a rapid, continuous, full arm stroke. Keeping a firm grip on the starter handle, let the rope return to the starter slowly. • After the engine starts, move throttle control to desired engine speed. Stopping Engine • Release blade control handle to stop the engine and the blade. • Disconnect spark plug wire and move away from spark plug to prevent accidental starting. Using Your Lawn Mower Your mower is designed to operate as a rear bagger, mulching or a side-discharge unit. • For converting from a mulcher to a side-discharge or a rear bagger unit, refer to instructions on page 8. Do not operate the mower without the mulching cover or the discharge chute properly installed and tightly secured. • Be sure that the lawn is clear of stones, sticks, wire, or other objects which could damage lawn mower or engine. Such objects could be accidently thrown by the mower in any direction and cause serious personal injury to the operator and others. • For best results, do not cut wet grass because it tends to stick to the underside of the mower, preventing proper discharge of grass clippings, and could cause you to slip and fall. New grass, thick grass or wet grass may require a narrower cut. Blade speed should be adjusted to the ...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории