Оценок - , средний балл:
(
)
)
Производитель: Cub Cadet
Размер: 1.26 mb
Название файла: 73f6081c-891d-4162-90ee-a40951c59900.pdf
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
Adjust as follows: (See Figure 32.) 1. Loosen (do not remove) the hex bolt and nut at the stationary idler bracket. 2. Slide the idler pulley upward to tighten the belt. Tighten hex nut and bolt. When no adjustment is left, have belt replaced. 1. Idler Pulley 2. Hex Nut 3. Bolt 4. Drive Belt 21 DRIVE BELT REPLACEMENT If drive belt replacement is required, contact your authorized Cub Cadet Dealer. BATTERY INFORMATION A WARNING A. Battery acid must be handled with great care as contact with it can burn and blister the skin. It is also advisable to wear protective clothing (goggles, rubber gloves and apron) when working with it. * B. Should battery acid accidentally splatter into the eyes or onto the face, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention. C. If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/ water. D. Since battery acid is corrosive, do not pour it into any sink or drain. Before discarding empty electrolyte containers, rinse them with a neutralizing solution. E. NEVER connect or disconnect charger clips to battery while charger is turned on as it can cause sparks. F. Keep all lighted materials (cigarettes, matches, lighters) away from the battery as the hydrogen gas generated during charging can be combustible. G. As a further precaution, only charge the battery in a well-ventilated area. * Always shield eyes and protect skin and clothing when working near batteries. A DANGER BATTERIES CONTAIN SULFURIC ACID AND MAY CONTAIN EXPLOSIVE GASES (when electrolyte has been added). KEEP BATTERIES OUT OF THE REACH OF CHILDREN. MAINTENANCE OF BATTERY 1. Check electrolyte level periodically (at least every two weeks). Keep the level to the split rings. Use only distilled water or a good quality drinking water. Never add acid or any other chemicals to the battery after initial activation. 2. The battery should be checked with a hydrometer after every 25 hours of operation. If the specific gravity is less than 1.225, the battery should be recharged. Maximum charge rate 5 amps. 3. Coat the terminals and exposed wire with a thin coat of grease or petroleum jelly for longer service and protection against corrosion. 4. The battery should be kept clean. Any deposits of acid should be neutralized with baking soda and water. Be careful not to get this solution in the cells. 5. Avoid tipping the battery. Even a “sealed” battery will leak electrolyte when tipped. STORAGE OF THE BATTERY 1. When storing battery for extended periods, disconnect battery cables. Removing battery from unit is recommended. 2. Keep the exterior of the battery clean, especially the top. A dirty battery must be stored with a full charge. A dirty battery will discharge itself. 3. Check the battery with a hydrometer. The battery must be stored with a full charge. A discharged battery will freeze. Specific Gravity Freezing Point 1.265 -71 °F 1.250 -62° F 1.200 -16°F 1.150 5°F 1.100 16°F NOTE All batteries discharge during storage. 4. Recharge battery whenever the specific gravity is less than 1.225, before returning to service or every two months, whichever comes first. COMMON CAUSES FOR BATTERY FAILURE 1. Overcharging 2. Undercharging 3. Lack of water 4. Loose hold downs and/or corroded connections 5. Excessive loads 6. Battery electrolyte substitutes 7. Freezing of electrolyte ■^NOTE These failures do not constitute warranty. 22 BATTERY REMOVAL OR INSTALLATION A WARNING 1. 2. When removing the battery, follow this order of disassembly to prevent your wrench from shorting against the frame. Remove the Negative cable. Remove the Positive cable. To install a battery: 1. Attach the Positive cable. 2. Attach the Negative cable. JUMP STARTING A WARNING Failure to use this starting procedure could cause sparking, and the gases in either battery could explode. 1. Attach the first jumper cable from the positive terminal of the good battery to the positive terminal of the dead battery. 2. Attach the second jumper cable from the negative terminal of the good battery to the FRAME OF THE UNIT WITH THE DEAD BATTERY. TIRES Keep the pneumatic tires properly inflated. Overinflation will cause operator discomfort. Underinflation will cause short tire life. Inflate the front and rear tires for normal or heavy load operations as shown in the following table: POUNDS PER SQUARE INCH 12 10 TIRE SIZE Front Tires 15x6-6 Rear Tires 20 x 10-8 Always see that the tire valve caps are in place and tightened securely to prevent loss of air and protect the valve core and stem. Do not overload the tractor tires by mounting equipment on the tractor which exceeds the load capacity of the size of the tires on the tractor. MOUNTING TIRES ON THE RIM After mounting a new or old tire on the rim, inflate it to 20 pounds pressure to seat the tire be...
Эта инструкция также подходит к моделям:Газонокосилки - 1220 (1.26 mb)