Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
Drain crankcase oil while engine is hot and refill with a grade of oil that will be required when unit is used again. 2. Prepare the mower deck for storage as follows: a. mower deck from the unit. b. Clean underside of mower deck. c. Coat all bare metal surfaces with paint or light coat of oil to prevent rusting. 3. Clean external surfaces and engine. 4. Prepare engine for storage. See engine owner’s manual. 5. Clean any dirt or grass from cylinder head cooling fins, engine housing and air cleaner element. 6. Cover air cleaner and exhaust outlet tightly with plastic or other waterproof material to keep out moisture, dirt and insects. 7. Completely grease and oil unit as outlined in the Normal Care section. 8. Clean up unit and apply paint or rust preventative to any areas where paint is chipped or damaged. 9. Be sure the battery is filled to the proper level with water and is fully charged. Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If battery is left in unit, disconnect the negative cable. WARNING Never store the unit, with gasoline in engine or fuel tank, in a heated shelter or in enclosed, poorly ventilated enclosures. Gasoline fumes may reach an open flame, spark or pilot light (such as a furnace, water heater, clothes dryer, etc.) and cause an explosion. Handle gasoline carefully. It is highly flammable and careless use could result in serious fire damage to your person or property. Drain fuel into an approved container outdoors away from open flame or sparks. 10. Drain fuel system completely or add a gasoline stabilizer to the fuel system. If you have chosen to use a fuel stabilizer and have not drained the fuel system, follow all safety instructions and storage precautions in this manual to prevent the possibility of fire from the ignition of gasoline fumes. Remember, gasoline fumes can travel to distant sources of ignition and ignite, causing risk of explosion and fire. NOTE:Gasoline, if permitted to stand unused for extended periods (30 days or more), may develop gummy deposits which can adversely affect the engine carburetor and cause engine malfunction.To avoid this condition, add a gasoline stabilizer to the fuel tank and run the engine a few minutes, or drain all fuel from the unit before placing it in storage. STARTING AFTER LONG TERM STORAGE Before starting the unit after it has been stored for a long period of time, perform the following steps. 1. Remove any blocks from under the unit. 2. Install the battery if it was removed. 3. Unplug the exhaust outlet and air cleaner. 4. Fill the fuel tank with fresh gasoline. See engine manual for recommendations. 5. See engine owner’s manual and follow all instructions for preparing engine after storage. 6. Check crankcase oil level and add proper oil if necessary. If any condensation has developed during storage, drain crankcase oil and refill. 7. Inflate tires to proper pressure. Check fluid levels. 8. Start the engine and let it run slowly. DO NOT run at high speed immediately after starting. Be sure to run engine only outdoors or in well ventilated area. 14 00 Notes 00 15 Regular Maintenance MAINTENANCE SCHEDULE & PROCEDURES The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of your operating time. Determining operating time is easily accomplished by observing the elapsed time recorded by the hour meter. SAFETY ITEMS See Page Before First Use Before Each Use Every 5 Hours Every 25 Hours Every 100 Hours Spring & Fall Check Safety Interlock System 9 X X Check Rider Brakes 22 X X Check Mower Blade Stopping Time 23 X X NORMAL CARE ITEMS See Page Before First Use Before Each Use Every 5 Hours Every 25 Hours Every 100 Hours Spring & Fall Check Rider/Mower for loose hardware — . . Check Engine Oil Level 16* . . . . Check Engine Air Filter 16* . ***. Change Engine Oil & Filter ** 16* ***. Every 50 Hours ***. Lubricate Rider & Mower 17 ***. Check Tire Pressure 15 . ***. Check Hydraulic Fluid 16 . ***. Check Fuel Filter 16 . Clean Battery & Cables 17 . Clean & Sharpen Mower Blades 18 . Inspect Spark Plug 16* . * See the engine manufacturer's owner's manual. ** Change original engine oil after first 5 hours of operation. *** More often in hot (over 85° F: 30° C) weather or dusty operating conditions. CHECK TIRE PRESSURES Tire pressure should be checked periodically, and maintained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires. The pressures shown provide proper traction, improve cut quality, and extend tire life. Tire Pressure Front 20 psi (1,38 bar) Rear 15 psi (1,03 bar) Figure 10. Checking Tire Pressure 16 00 Regular Maintenance CHECKING / ADDING FUEL To add fuel: 1. Remove the fuel cap (see A, Figure 2). 2. Fill the tank to the bottom of the filler neck. This will allow for fuel expansion. NOTE: Do not overfill. Refer to your engi...
Эта инструкция также подходит к моделям:Газонокосилки - 1000ZK23/52 (1.83 mb)
Газонокосилки - 1000ZK27/61 (1.83 mb)
Газонокосилки - 1000ZKAV21/48 (1.83 mb)
Газонокосилки - 1000ZKAV21/48CE (1.83 mb)