Войти:
Оценок - 6, средний балл: 3.7 ( )

Инструкция по эксплуатации Cleveland Range, модель Open Base & Modular Gas Skillet SGL-40-TR

Производитель: Cleveland Range
Размер: 756 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


All units are equipped with fixed orifices and do not require primary air adjustment. LIGHTING INSTRUCTIONS NOTE: This appliance is equipped with a direct spark ignition system. Ensure gas and electrical supply to the appliance, are in the 'ON' position. 1. Turn the main manual gas shut-off valve to the 'ON' position. 2. Turn power switch to the 'ON' position. 3. Set thermostat to desired temperature. 4. If ignition fails and/or the control system goes into lockout, set power switch to the 'OFF" position. 5. Wait 5 minutes then repeat steps 1 through 3. If the problem persists, have a qualified serviceman check the system. 6. To shutdown system, turn power switch and main manual gas valve to the 'OFF' position. OPERATING INSTRUCTIONS 1. Ensure gas and electrical supply to the appliance are in the 'ON' position. 2. Turn power switch to the 'ON' position. The green pilot light will indicate power is on. Wait one minute to allow flame sensor to heat up. 3. TILTING OPTIONS Note: Before tilting the pan make sure the lid is open. PowerTilt Cleveland skillets are equipped with an electric power tilt mechanism for raising and lowering the frypan. To raise frypan, raise the cover and press up on the tilt switch. To lower frypan, press down on the tilt switch. Manual Tilt Cleveland skillets can also be equipped with the optional manual tilt mechanism for raising and lowering the frypan. To raise frypan, raise the cover and turn the wheel clockwise. To lower frypan, push in on the lever located behind the wheel. 4. FOR YOUR SAFETY, this skillet is also equipped with a power interrupter which automatically shuts off the gas supply to the burners whenever the skillet is raised more than 1/2" (13mm). 5. Turn power switch to the 'OFF' position when skillet is not in use. 6. During an electrical power interruption, turn power switch to the 'Off position. This unit cannot be made to operate without electrical power or gas supply. OPERATING SUGGESTIONS IMPORTANT: Always raise the spring assist cover before activating the tilt mechanism. Before commencing to cook, ensure frypan is in the lowered position by pressing down on the tilt switch. 1. To preheat, set thermostat to desired cooking temperature. The amber pilot light will cycle on and off with the thermostat. 2. Allow skillet to preheat for approximately 15-30 minutes. 3. Once preheated, insert product in skillet and adjust thermostat to required cooking temperature. 4. If desired, once product has cooked, it can be held prior to serving at a lower temperature setting. 5. When cooking is completed, set thermostat and power switch to the 'OFF' position. 6. The best time to clean the skillet is immediately after use, once skillet has cooled down. CLEANING INSTRUCTIONS CAUTION SURFACES MAY BE EXTREMELY HOT! CARE AND CLEANING Cooking equipment must be cleaned regularly to maintain its fast, efficient cooking performance and to ensure its continued safe, reliable operation. The best time to clean is shortly after each use (allow unit to cool to a safe temperature). WARNINGS . Do not use detergents or cleansers that ...

Эта инструкция также подходит к моделям:
Фритюрницы - Open Base & Modular Gas Skillet SGL-30-TR (756 kb)
Фритюрницы - Open Base & Modular Gas Skillet SGL-30-TR (756 kb)
Фритюрницы - Open Base & Modular Gas Skillet SGL-30-TR (756 kb)
Фритюрницы - Open Base & Modular Gas Skillet SGL-30-TR (756 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории