Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Improper installation of product could cause injury or damage. This equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are: UL, NSF, ASME/Ntl.Bd., CSA, ETL, and others. Many local codes exist, and it is the respunsibilrtjr'of'tbe^ owiier'-andr installer to comply with these codes. INSPECTION Before unpacking visually inspect the unit for evidence of damage during shipping. If damage is noticed, do not unpack the unit, follow shipping damage instructions. SHIPPING DAMAGE INSTRUCTIONS If shipping damage to the unit is discovered or suspected, observe the following guidelines in preparing a shipping damage claim. 1. Write down a description of the damage or the reason for suspecting damage as soon as it is discovered. This wül help in filling out the claim forms later. 2. As soon as damage is discovered or suspected, notify the carrier that delivered the shipment 3. Arrange for the carrier’s representative to examine damage. 4. Fill out all carrier claims forms and have the examining carrier sign and date each form. Hie serial plate is located on the left hand box cover. Remove front liftoff cover for access. Voltage, phase, amperage and wattage are stated on the plate. 1. Damage check: Check carton or crate for possible damage incurred in shipping. After carefully uncrating, check for "concealed" damage. Report any damage immediately to your carrier. 2. Check the electrical rating plate to ensure that the unit is correct voltage* . amperage*, phase and wattage. 3. This unit must be installed by a qualified electrician working in accordance with applicable local and national electrical codes. Improper installation could cause damage and void the warranty. INSTALLATION CLEARANCES This unit must be installed in accordance with the following clearances in order to provide proper operation and servicing of the appliance. Also, it is recommended that the unit be installed with sufficient clearances to provide proper cleaning and maintenance. Minimum clearances are 1" for the sides and back. INSTALLATION 1. Carefully remove unit from carton or crate. Remove any packing material from unit On stainless steel panels, the protective material should be removed before the unit is installed. 9111 REV:1 2 4ШОТЕ 2. Set skillet in position where electrical services are nearby. Comply with clearances stated on the specification sheet Ensure there is sufficient clearance between skillet and back wall. Check overhead clearance to accommodate hinged cover when in the raised position. 3. Level skillet by means of adjustable stainless steel feet Use a spirit level to level unit four ways; across front and back and down left and right edges. Securely anchor adjustable feet to floor and seal joints-with-a~s2fcone*seaiant ~ ELECTRICAL CONNECTION 1. A direct electrical connection is required at the terminal block located near the left side of the unit The supply line will enter through re...
Эта инструкция также подходит к моделям:Фритюрницы - SEL-T (890.48 kb)
Фритюрницы - SEL-T (890.48 kb)
Фритюрницы - SEL-T (890.48 kb)
Фритюрницы - SEM-T (890.48 kb)