Войти:
Оценок - 4, средний балл: 3.5 ( )

Инструкция по эксплуатации Canon, модель EOS-1D Mark II

Производитель: Canon
Размер: 5.24 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



К этому устройству также есть другие инструкции:

Фрагмент инструкции


Replace with a formatted Err 03 memory card. The memory card is full. Erase unnecessary images in the card Err 04 or replace the memory card. An error other than the above has occurred. This error may occur if you use a non-Canon lens and the Err 99 camera or lens does not operate properly. Remove and reload the battery. 165 Changing the Focusing Screen You can change the camera’s focusing screen to better suit the subject or shooting situation.You must also set C.Fn-00 so that the standard setting for obtaining a correct exposure matches the focusing screen. Focusing Screen Type Designation C.Fn-00 Setting k:New Laser-matte Screen Ec-N, Ec-R 0 l:Laser-matte Screen Ec-series (A, B, C, CII, CIII, D, H, I, L) 1 1 Select C.Fn-00. .Hold down the button and turn the <5> dial to select [00]. Then let go of the button. .Hold down the button and turn the <5> dial to select the desired setting. Then let go of the button. 2 Check the message. .Hold down the button and turn the <5> dial to select [OK]. Then let go of the button. C.Fn-00 cannot be registered in any Custom Function group. .If you do not change the focusing screen that came with the camera, you need not change C.Fn-00-1 factory setting. .To change the focusing screen, refer to the instructions that came with the focusing screen. .The Ec-A, Ec-B, Ec-I, and Ec-L focusing screens have a prism at the center. A correct exposure reading cannot be obtained with evaluative metering or spot metering based on the center area where there is a prism. Use centerweighted averaged metering or off-center spot metering with such focusing screens. Ec-series Interchangeable Focusing Screens Ec-A: Standard microprism Ec-H: Laser-matte with scale Ec-B: New split screen Ec-I: Laser-matte with cross hair Ec-CII: All Laser-matte Ec-L: Cross split screen Ec-CIII: Laser-matte Ec-N: New Laser-matte Ec-D: Laser-matte with grid Ec-R: New Laser-matte 167 Major Accessories (Optional) Ni-MH Pack NP-E3 Dedicated, high-capacity power pack. Rated voltage of 12 V. It can be recharged up to 500 times. When fully charged, it enables the camera to take up to about 1200 shots at normal temperature. Ni-MH Charger NC-E2 Quick charger dedicated to the Ni-MH Pack NP-E3. Excess charging prevented. It takes about 120 minutes to recharge one pack. Two packs can be attached to it at one time. The discharge function takes about 8.5 hours to cancel the pack’s memory effect. It runs on 100 - 240 VAC. Shoe-mount Speedlites Flash photography with an EX-series Speedlite is as easy as normal auto exposure shooting without flash. All EX- series Speedlites enable E-TTL II autoflash, high-speed sync (FP flash), and FE lock. With the 550EX, an easy-touse, wireless E-TTL II autoflash system is possible with multiple Speedlites. Macro Ring Lites The EX-series Macro Lites are ideal for close-up flash photography. You can fire only one or both flash tubes and control the flash ratio to easily obtain sophisticated lighting effects with E-TTL II autoflash. Also, high-speed sync (FP flash), FE lock, and a multi-Speedlite, wireless system (with 550EX or 420EX as a slave) are possible to achieve various macro flash effects. Remote Switch RS-80N3 This is a remote switch with an 80 cm cord to prevent camera shake for super-telephoto shots, macroshooting, and bulb exposures. The switch has the same effect as pressing the shutter button halfway or completely. A shutter-release lock is also provided. The quick-lock plug connects to the camera’s remote control terminal. Timer Remote Controller TC-80N3 Attached with an 80-cm cord, this remote switch has four built-in functions: 1.Self-timer, 2.Interval timer, 3.Bulbexposure timer, and 4. Shutter-release count setting. The timer can be set anywhere from 1 sec. to 99 hours, 59 min. , 59 sec. in 1-sec. increments. The connection plug for the camera has a quick-lock feature. Wireless Controller LC-4 Wireless controller effective up to 100 meters. It consists of a transmitter and receiver. The receiver’s camera connection plug connects to the camera’s remote control terminal. E-series Dioptric Adjustment Lenses One of ten E-series dioptric adjustment lenses (–4 to +3 diopters) can be attached to the camera’s eyepiece to further expand the dioptric adjustment range. Memory card Data storage media where the captured images are recorded. Using Canon memory cards is recommended. PC card adapter Enables a CF card to be inserted into a PC card slot or PC card reader. 169 System Map Macro Ring Lite ST-E2 220EX 420EX 550EX MR-14EX Macro Twin Lite MT-24EX Eyecup Ec-II Anti-Fog Eyepiece Ec Rubber Frame Ec E-series Dioptric Adjustment Lenses Angle Finder C Wide Strap L5 Hand Strap E1 Focusing Screen Ec Ni-MH Pack NP-E3 Ni-MH Charger NC-E2 DC Coupler Kit DCK-E1 CR2025 lithium battery EOS DIGITAL Solution Disk Digital Photo Professional Disk Bundled Accessories 171 CF card SD memory card Card reader Data Verification Kit PC card adapter DVK-E2 Interface Cable IFC-200D4 Interface Cabl...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории