Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
CONSUMERS:- ATTENTION: The product you have purchased is powered by a nickel cadmium battery . which is recyclable. At the end of its useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. v Please call 1-800-8-BATTERY for information on how to recycle this battery. j 8 To avoid damage to the Battery Pack: • Do not drop or jar the Battery Pack. ■ Use the Battery Pack with specified units only. To insure longer Battery Pack life: • While not in use, remove the Battery Pack from the Digital Camera and store in a dark, cool, dry place. • Keep the Battery Pack terminals clean. Power Supply Charging the Battery Pack (PV-BPN10 or PV-BPN10/1B only) Install the Battery Pack (see page 8.) Charge the Battery Pack fully before operation. qq Connector 1 Connect DC OUT on the AC Adaptor to DC IN on the Digital Camera Station until it locks with a click. 2Plug the AC Adaptor into an AC outlet. The POWER Lamp lights up. ^Insert the Digital Camera into the Digital Camera Station until it locks. 4Slide the CHARGE switch. The CHARGE Lamp lights orange, and then changes to green when charging is done (just under 2.5 hours). A red CHARGE Lamp indicates a charge malfunction. Remove the Digital Camera and repeat steps 3 and 4. If the CHARGE Lamp is still red, send the unit in for service. 5Slide the RELEASE switch to release the Digital Camera from the Digital Camera Station. • With a fully charged Battery Pack, you will have a maximum of about 50 minutes* of continuous playback{77°F/25°C). * When playback 1 image every 60 seconds. • The useful operation time of the Battery will gradually decrease after repeated use and recharging. The Battery is no longer serviceable if the operation time is very short, even after a sufficient charge. • Instead of the supplied Battery Pack, you can also use AA type Ni-Cd (high density type) or nickel-hydride batteries available on the market. • For emergency use you can install 2 Panasonic alkaline batteries. But, due to power consumption and shorter operation life of alkaline batteries compared to the supplied rechargeable battery pack, it is strongly recommended that only the Optical Viewfinder (turn oft the LCD Viewfinder) be used to capture images when using alkaline batteries. • If you are not going to use the Digital Camera for an extended period of time, remove the Battery Pack from the Digital Camera. ^CAUTION ' Discharge the remaining voltage of the Battery Pack completely before charging. This is vital to maintain battery life and the operation time due to characteristics of the battery. Do not remove the Digital Camera while ^ charging is in progress.__ф 9 Power Supply AC Adaptor DC IN Connector 1 Connect DC OUT on the AC Adaptor to DC IN on the Digital Camera Station until it locks with a click. ' ^?insert the Digital Camera into the Digital Camera Station until it locks. ^^Plug the AC Adaptor into an AC outlet. • The POWER Lamp lights up. Note: • While not in use, unplug the AC Adaptor from the AC outlet. 10 Setting the Clock Set the POWER switch to REC or PLAY. The LED Lamp lights up. Press OSD and MODE at the same time to display the clock set screen. CUOCXiSET -10.4)0-AM- MAR d11998 SEL + /- SET OSD *7 Press (+) or (-) to select the correct hour, then press OSD to set. 4 Repeat step 3 to select and set the correct minute, month, date, and year. • Double check all items before setting the year. Note: • To make corrections, repeat steps 2-4. • The clock will continue to operate about 8 hours after the battery has been removed. If you need to reset the clock, repeat steps 2-4. 11 Using the Flash Install the battery 1 Open the Battery Compartment lid by sliding it in the direction of the arrow, as shown above. 2Install the battery as indicated inside the Battery Compartment. • Do not reverse the battery polarities (-) and (+). Incorrect use may shorten battery life, causing the battery to become hot, leak or explode. • Make sure the battery is firmly in place to avoid a loose connection. Remove the battery • Pull up the string in the battery compartment and remove the battery. Г CAUTION Replace with Panasonic CR2 Lithium batteries only. Use of another battery may present a risk of fire or explosion. Caution-battery may explode if mistreated. Fire and burn hazard. Do not recharge, disassemble, or dispose of in fire. Keep battery out of reach of children. Danger of explosion if battery is incorrectly inserted. Dispose of used battery promptly. When disposing of the used Lithium Battery be sure to insulate the battery polarities (+) and (-) by covering with ^ cellophane tape._ 12 Using the Flash Attaching the Flash 1 Pull up on the connecting plug from its retracted position as shown above. 2Connect to the digital camera connecting jack. 3Rotate thumbwheel to secure the flash. • Be sure to set the Digital Camera and the flash unit ...