Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
1 Rinse with water with the side door closed. • After use at the seaside or underwater, soak the unit in fresh water pooled in a shallow container for 10 minutes or less. • If the zoom button or camera [ON/OFF] button do not move smoothly, it may be caused by an adhesion of foreign objects. Using in such a state may cause malfunctions, such as locking up, so wash off any foreign objects by shaking the camera in fresh water. • Bubbles may come out of the drainage hole when you immerse the camera in water, but this is not a malfunction. (ENG) VQT4A80 13 2 Drain water by holding the camera upside-down A and the right way up B and shaking it lightly a few times. • After using the camera at the beach or in water, or after washing it, water may remain around the speaker and microphone for a while and may cause a drop in volume or sound distortion. • Fasten the strap firmly to prevent the camera from dropping. 3 Wipe off water drops on the camera with a soft, dry cloth and dry the camera in a shaded area that is well ventilated. • Dry the camera by standing it on a dry cloth. This unit incorporates drain design, draining water in gaps in the camera [ON/OFF] button and zoom button etc. • Do not dry the camera with hot air from dryer or similar. Waterproof performance will deteriorate due to deformation. • Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or detergents. 4 Confirm that there are no water droplets, open the side door, and wipe off any water droplets or sand left inside using a soft, dry cloth. • Water droplets may adhere to the card or battery when the side door is opened without thoroughly drying. Also, water may accumulate in the gap around the card/battery slot or the terminal connector. Be sure to wipe any water off with a soft, dry cloth. • The water droplets may seep into the camera when the side door is closed while it is still wet, causing condensation or failure. 14 VQT4A80 (ENG) Names and Functions of Main Parts 23456 7 8 9 1011 ................................ . . 222324 12 13 14 20 21 19 1817 15 1 Flash 2 Motion picture button 3 Shutter button 4 Camera [ON/OFF] button 5 Microphone 6 Self-timer indicator/ AF Assist Lamp 7 Lens 8 LCD monitor 9 [MODE] button 10 Zoom button 11 Strap eyelet • Be sure to attach the strap when using the camera to ensure that you will not drop it. 12 Release lever 13 [LOCK] switch 14 Side door 15 [(] (Playback) button 16 [Q.MENU]/[ ] (Delete/Cancel) button 17 [DISPLAY] button 18 [MENU/SET] button 19 Cursor buttons 20 Speaker • Be careful not to cover the speaker with your finger. Doing so may make sound difficult to hear. 21 Tripod receptacle 22 [AV OUT/DIGITAL] socket 23 Card slot 24 Battery slot (ENG) VQT4A80 15 Charging the Battery Use the dedicated charger and battery. • The battery is not charged when the camera is shipped. Charge the battery before use. • Charge the battery with the charger indoors [10 oC to 30 oC (50 oF to 86 oF)]. Attach the battery paying attention to the direction of the battery. Connect the charger to the electricaloutlet. • The [CHARGE] indicator A lights up and charging begins. .About the [CHARGE] indicator On: Charging. Off: Charging has completed. (Charging time: Approx. 120 min) .About batteries that you can use with this unit The battery that can be used with this unit is DMW-BCK7PP. 16 VQT4A80 (ENG) Inserting and Removing the Card (optional)/the Battery • Check that this unit is turned off. • Confirm that there is no foreign object. • We recommend using a Panasonic card. 1:Slide the [LOCK] switch A, and release the lock. 2:Slide the release lever B and open the side door. • Always use genuine Panasonic batteries (DMW-BCK7PP). • If you use other batteries, we cannot guarantee the quality of this product. ........ Battery: Being careful about the battery orientation, insert all the way until youhear a locking sound and then check thatit is locked by lever C. Pull the lever C in the direction of the arrow to remove the battery. Card: Push it securely all the way untilyou hear a “click” while being carefulabout the direction in which you insert it. To remove the card, push the card until itclicks, then pull the card out upright. D: Do not touch the connection terminals of the card. Close the side door until it clicks, and then lock the [LOCK] switch by sliding ittoward [2]. • Confirm that the red part on the [LOCK] switch is not showing. Note • Keep the Memory Card out of reach of children to prevent swallowing. ........ (ENG) VQT4A80 17 Sequence of operations Press camera [ON/OFF] button. • The clock is not set when the camera is shipped. Set the date and time before using the camera. Press the shutter button halfway tofocus and then press it fully to take the picture. .Selecting the Recording Mode Press [MODE] to select the Recording Mode. : Take pictures with automatic settings. : Take pictures with your own settings. : This mode is optimal for taking pictures of sporting events, etc. : This mode is optimal ...