Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Return immediately for service. 4. Press the reset button to reactivate the ESP/ALCI safety device and use the appliance. At any time, should this unit detect an electrical shock hazard, it will immediately shut off. To restore power, the reset button on the ESP/ALCI safety device must be pressed to reactivate the circuit. Repeat the above procedure each time this appliance is used to confirm that the safety device is operational. IMPORTANT: Never block air intake grille, as this will cause the unit to overheat. Should this happen, a built-in safety system will operate, and the unit will shut off automatically. At this point, turn the switch to Off, and clear any obstruction from the air intake grille. Wait 10 minutes before attempting to operate appliance again. If the unit fails to operate, it may indicate that the appliance has sustained extensive damage. Do not try to repair it yourself. Take it to an electrical service facility, or return it to the manufacturer. See warranty for instructions. CAUTION: Heating section should never be touched as it may be hot and burns may occur. To avoid possible scalp or hair burns, use very hot setting only when hair is wet. Reduce to lower heat as hair dries. Do not keep appliance directed at one place; keep it in constant motion. This is especially important if drying a wig, which could be damaged by heat. For maximum airflow, hold dryer no closer to the head than six inches. SPECIAL ATTENTION: This appliance is designed with a protective coating around the heating coils. When operating the first few times, there may be momentary smoking when unit is switched OFF. This represents no danger to the user and does not indicate a defect in the unit. This smoke should dissipate within a short time. To extend the life of the dryer, it is advisable to switch it to the low heat setting for a few seconds before shutting it off. HOW TO USE THIS DRYER This dryer features a choice of two speeds and two heat settings. Use high heat/speed for most styling/setting procedures and hair types. Select lower heat/speed for "finishing" a hairstyle or for drying and styling permed, color- treated or fragile hair. TO USE THE COOL SHOT BUTTON: The Cool Shot button is located at the top of the dryer handle. By depressing the button, the airflow will become cool. The Cool Shot is used to set curls in place. Press the button and hold it for length of time desired. When finger is released from the button, the dryer will automatically resume the temperature and speed previously chosen. TO USE THE POWER BOOST BUTTON: The power boost button is located underneath the Cool Shot button near the top of the dryer handle. By depressing the power boost button the dryer fan speed will increase to generate more airflow for a short period of time. The use of this button helps to decrease drying time. Depress the button and hold it for no longer than three minutes at a time. When finger is released from the button the dryer will automatically resume the temperature and speed previously chosen. ION GENERATOR: This dryer is equipped with a built-in ion generator that automatically generates negative ions when the unit is operating. It is ideal for overall hair conditioning. CARE AND CLEANING This appliance is permanently lubricated and will not require additional lubrication for the life of the unit. It contains no user serviceable parts. Refer service to qualified service personnel. WHILE USING: Untwist cord from time to time to avoid tangling. TO CLEAN: Unplug unit and allow to cool. Use a soft, slightly damp cloth to wipe the surfaces. Do not allow water or any other liquid to get into the unit. Intake grille must be cleared of any build-up of lint or hair with a small brush. To remove grille: Place thumb on the removable grille just above the indent. Apply pressure, pushing up to loosen grille then lift off. To replace grille: Place wider tab located on the top of the removable grille into the slot on the top of the dryer back. Apply pressure on both sides of the removable grille until it snaps into place. TO STORE: Unplug appliance, allow to cool, and store in its box or in a dry place. Never store it while it is hot or still plugged in. Never wrap the cord tightly around the appliance. Never hang unit by the cord -- use the hanging ring provided. Do not put any stress on the cord where it enters the unit, as it could cause the cord to fray and break. SERVICE NOTE: Before returning unit for service, please make sure the air intake grille is free of lint and hair. If it needs cleaning, clean by hand with a small brush, or use a vacuum cleaner brush attachment. If unit has a removable grille, be sure to clean the fixed grille attached to the housing as well as the removable grille. Then try to operate the unit again. CONSEJOS DE SEGURIDAD PARA EL CABLE ELECTRICO 1. Nunca hale ni tire del cable ni de la unidad. 2. Para conectar, sujete con firmeza el enchufe y guielo dentro de la toma de corriente. 3. Para d...