Оценок - 5, средний балл: 4.2
(
)
)
|
Фрагмент инструкции
Series Set Up the Machine Unless otherwise mentioned, illustrations used in this manual are those taken when no optional equipment is attached to the MF6580, and also the menus described in this manual are based on the model MF6580. Depending on the model of your machine, some settings may not be available and the number on the top of each menu may vary. Do You Have Everything? * MF6550/ MF6560/ MF6580 Only **MF6560/ MF6580 Only Before Setting Up the Machine Manuals for the Machine . Remove all shipping tape on the machine. . When moving the machine, be sure at least two people carry it using the provided hand grips on the left and right sides, as seen in the illustration right. . The machine illustration may differ slightly from your machine. . Starter Guide (This Document): Machine set-up and software installation . Basic Guide: Basic features, maintenance, machine settings, and specifications . Advanced Guide (in User Software CD): Advanced features, network and remote user interface, system monitor, and reports and lists . Scanner Driver Guide (in User Software CD): Scanner settings from a computer .Machine .Paper Cassette (optional)** .Toner Cartridge .Power Cord .Telephone Cable* .Destination Labels* .Starter Guide .Basic Guide .User Software CD .Limited Warranty Notice .Registration Card .Unpacking Instructions 1 2 3 Install Toner Cartridge 1 Remove the toner cartridge from the bag. Keep the bag for future use. CAUTION Do not open the drum protective shutter (A). 2 Gently rock the toner cartridge 5 or 6 times to distribute toner evenly. 3 Remove the seals (2 places). 4 Raise the blue plastic pull tab as in the illustration above. 5 Pull out the seal completely. NOTE Do not pull out the seal at an angle. 6 Open the left cover. 7 Hold the toner cartridge by its handle. Insert the toner cartridge into the machine with the arrows (A) on the toner cartridge pointing toward the machine. 8 The left edge (A) and the right side protrusions (B, C) of the toner cartridge should be aligned with the guides inside the machine. The Blue plastic pull tab should be pulled up as illustrated in step 4. 9 Push the toner cartridge to make sure it is properly set in the machine. CAUTION Do not touch the fixing assembly (A) as it becomes very hot during use. 10 Close the left cover. CAUTION – Be careful not to get your fingers caught. – If you cannot close the left cover, do not force it to close. Open the cover and make sure the toner cartridge is properly set in the machine. A A B C A A 4 5 Load Paper 1 Pull out the paper cassette until it stops. 2 Even the edges of the paper stack. 3 Load the paper stack print side up. NOTE Make sure the back edge of the paper stack touches the rear paper end guide (C), the paper stack should not exceed the load limit mark (A), and the load is under the hooks (B) on the paper guides. 4 Gently insert the paper cassette as far as it will go. CAUTION Be careful not to get your fingers caught. NOTE For loading paper in the multi-purpose tray, see Chapter 3, “Print Media,” in the Basic Guide. Set Up the Paper Cassette to Fit the Paper Size Connect Telephone Cables (MF6550/MF6560/MF6580 Only) 1 Incline the rear paper end guide until it is unlocked, then remove it from the paper cassette. 2 Attach the guide to the slots of the desired paper size. Connect the supplied telephone cable to the line jack (A) and the wall jack. Connect your external telephone to the external device jack (B) if required. A B B C A B 6 What if... What if... .