Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
safety goggles) when drilling holes, etc. • Before drilling holes in walls, check for hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like; danger of damage if battery is incorrectly replaced. Replace only with the same or equivalent type. 1. Checking Pack Contents • Chime • Bell push • CR2032 battery for bell push • 2 x screws for push • 2 x wall plugs • Adhesive pad You will need: • 3 X LR14 C size 1.5V Alkaline batteries • A #1 Philips-head screw driver • A small flat bladed screwdriver • A 1/4-in. (6 mm) drill bit 2. Installing Batteries M27182CR2032+ CR2032+ +– +– M27178+– LR14 C SIZE 3. Change Tune or Program New Push Press and release programming button, LED will illuminate, press push button to hear the tune. Press push button again to hear another tune. To save the tune selected, press and release programming button. Note: Pressing the program button for more than 15 sec will erase all memory. Follow step 3 to re-program. M27183 M27145 4. Install Back Cover Using Screws or Adhesive Pad Provided Note: Before final installation adjust distance and position between push and chime to optimize the chime within your environment. Dense walls and metal can reduce range. TOPTOPM27184 Wall Type Range Reduction Dry-lined partition wall 10–30% Single-layer brick wall 20–40% Double-layer brick wall 30–70% Metal panel/radiator 90–100% 5. Volume Adjustment 6. Strobe and Sound Selections Light and sound selection (applicable to RCWL210A only). M27180 7. Low Battery Indication Tune + 2 beeps + 2 LED flashes = change batteries in chime. Tune + 3 beeps + 3 LED flashes = change battery in push. M27181+– +– +– +BEEP2+BEEP3+ + x 2x 3CR2032+ CR2032+ Specification Chime Bell Push Operating Temperature 32°F to 104°F 0°C to +40°C 14°F to 104°F -10°C to +40°C RF Frequency – US 345MHz 345MHz Range (open field) 200 ft (61 m) Sound Level (typical) 82dBA @ 3 ft (1m) RF Power <1mW Battery Type LR14 C size CR2032 Battery Life (5 operations/day) 12 months 18 months Water Proof Pass UL rain test Tunes Ding Dong 4 notes Modern 8 notes Westminster Saxophone Sound Troubleshooting Two ‘beep’ sounds are heard and LED flashes twice after the normal chime sound… This indicates a low battery in the chime. Install new batteries, type LR14 C size alkaline batteries. Three ‘beep’ sounds are heard and LED flashes three times after the normal chime sound… This indicates a low battery in the bell push that activated the chime. Install a new battery, type CR2032. When the bell push is operated, the red confidence light does not turn on, or is only on for a short time… Low battery. Install a new battery, type CR2032. The chime does not work… • Check that the batteries are the correct type. Only use alkaline batteries for chime. • Check that the batteries are fitted correctly (no wrong polarity). • Check that batteries are not loose. • The chime could be out of range of the bell push. Try the chime in a different locati...
Эта инструкция также подходит к моделям:Двери и окна - RCWL210A (1.67 mb)