Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Miter Extension Fence Moved Away from Cutter Figure C Step 3: Assembly The illustrations below show the typical style, rail and glass layout. Note the glazer’s points which secure the pane on the back side of the frame. They can be obtained from your local hardware store along with the putty needed to finish and seal window. Doors having more intricate designs such as arched, tombstone or curved panels should only be done when you are confident of your ability. If your project requires curved pieces then freehand routing using the bearing and starter pin will be necessary. Remember that it is important to work with good quality material and to insure that all pieces are machined the same and that all ends and edges are cut square. Follow all recommended safety procedures and always test the setup using sample pieces. Gap Glass Pane Glazer's Putty Point 529003622 © May 2003 Grizzly Industrial, Inc. ...
Эта инструкция также подходит к моделям:Двери и окна - 1551 (155.38 kb)
Двери и окна - 1553 (155.38 kb)
Двери и окна - 1554 (155.38 kb)
Двери и окна - C1550 (155.38 kb)