Оценок - 4, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
The last tune played will be stored after the icon stops flashing. To confirm, press the push button and chime will play the tune you want. Installation 7. To add new push/reprogram Press and hold the program button l. The icons will illuminate in sequence. Release the program button when icon you choose is illuminated. Operate your new push and the chime will play tune, icon will flash. To change tune, refer to step 6. 8. Unlearn procedure To remove a push from the chime’s memory, press and hold the program button l. Each icon will light in turn. When the icon associated with the push to be un-learned is lit, release the button. Then press and hold down both l and buttons, until a ‘beep’ sound is heard. 9. Recall function A short push of the program button l will flash the icon that was last in use. 10. Mount the bell push Install back cover to wall, use screws provided/adhesive pad. Close the cover. Note: Before final installation adjust distance and position between push and chime to optimize the chime within your environment. Dense walls and metal can reduce range. Installation TOP Wall Type Range Reduction Dry-lined partition wall 10–30% Single-layer brick wall 20–40% Double-layer brick wall 30–70% Metal panel/radiator 90–100% 11. Mount the chime Mounting holes are marked with screw symbol. Clip on the front cover. 12. For stainable covers only Choose your paint, stain or varnish and then apply to the cover. Follow manufacturers’ advice on the paint/vanish. It is possible to unscrew the four screws shown below for painting. Ensure you screw it back with the same screws provided! Once completed, clip it onto the base as in step 11. Installation Specification Chime Bell push Operating Temperature 32°F to 104°F 0.C to 40.C 14°F to 104°F -10.C to 40.C RF Frequency- US 916.8 MHz 916.8 MHz Range (open field) 450 ft. (140 m) Sound Level (typical) 90dBA @ 3 ft. (1 m) - RF Power - <1mW Battery Type LR14 (C size) CR2032 Battery Life (5 activations/day) 12 months 18 months Rain proof N/A Pass UL1598 rain test Troubleshooting A ‘beep’ sound is heard in learn mode… • The push you are programming has already been learned by the chime. • If you want to change the icon associated with the push, use the unlearn procedure, then program the push again. Two ‘beep’ sounds are heard after the normal chime sound… • This indicates a low battery in the bell push that activated the chime. Install a new battery, type CR2032. When the bell push is operated, the amber confidence light does not turn on, or is only on for a short time… • In normal operation, the amber light will turn on for 1 second. When the battery is weak, the light will only turn on for a short time. Install a new battery, type CR2032. The chime does not work… • Check that the batteries are the correct type, LR14 ‘C’ cells. Only use alkaline batteries. • Check that the batteries are fitted correctly. (No wrong polarity) • The chime could be out of range of the bell push. Try the chime in a different l...
Эта инструкция также подходит к моделям:Двери и окна - RCWL3501A (1.63 mb)
Двери и окна - RCWL3503A (1.63 mb)
Двери и окна - RCWL3504A (1.63 mb)
Двери и окна - RCWL3505A (1.63 mb)