Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Layer change Many DVD discs have two layers to increase the available playback time (these DVDs are identified as type DVD-9 or DVD-18). Often, there will be a short pause in the video and audio of about a second whenever the laser of the player refocuses from one layer to the next. Fast play Press or on the front panel or remote control to play fast forward or backwards. For DVDs, VCDs and CDs the following speeds for fast playback are available: x2, x4, x8, x20, x60 and x100. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY. Fast playback is not available for MP3 discs. Skipping chapters/tracks To skip chapters (or tracks on a CD), press or . When skipping back, the first button press takes you to the beginning of the current chapter. Pressing the button again takes you to the start of the previous chapter. Note that it is common for Video CDs to have only one track. Pausing playback Press PAUSE on the front panel or on the remote control to pause playback. To resume playback, press PLAY on the front panel or on the handset. Stopping playback Press the STOP button on the front panel or on the remote control to stop playback. When playing a DVD, pressing STOP once performs a ‘resume stop’. If you now press PLAY, playback resumes from the point it was stopped. If you press STOP twice, this is a ‘complete stop’, and playback resumes from the beginning of the disc. Front panel menu navigation Should you need to navigate a disc or title menu from the front panel, use PAUSE for ‘up’, STOP for ‘down’ , for ‘right’, for ‘left’ and PLAY for ‘OK’. DV89 11 DV89 12 Using the remote control OK ANGLE CD DVD SETUP STATUS SRCH ZOOM AUDIO MEM RTN P MODE SUBT TITLE MENU RPT CLEAR 0 PROG A-B 7 8 9 DISP 4 5 6 CD DVD 1 2 3 MUTE OPEN CD/DVD REMOTE CR-314 CD/DVD Ensure that DVD mode is selected using the CD/DVD toggle button. The ‘DVD’ LED above the CD/DVD button is lit briefly when DVD mode is selected. DISP (display) Dims or turns the DV89’s display on or off. Turning the display off generally gives a slight improvement in sound quality. Pressing DISP once turns the display off; twice dims the display. To restore the display to full brightness, press DISP a third time. A–B This button enables you to repeat a selected section from the disc (see page 14). RPT (repeat) Press RPT to cycle through the repeat play options. CLEAR Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear a numeric field (see pages 14–15). 0–9 keypad This allows direct access to individual tracks on audio CDs. To select a track, press the corresponding keypad button followed by OK. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press 1, then 5, then OK. PROG (program) You can program a selection of up to 20 chapters/tracks from a disc to play in any order. Press PROG to access the ’Programme’ menu (see pages 15 and 17). MUTE Stops sound to the speaker outputs of certain Arcam amplifiers. Volume +/– Adjusts the volume on Arcam remote-controllable amplifiers. Note that the volume (+/–) controls and MUTE button have no effect on the audio output level of the DVD players. NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control. Do not place anything in front of the display area on the DVD player (where the IR receiver is located), or the remote control may not work. OPEN Opens and closes the disc tray. Page Up/Down (DVD-audio)/Slow play (other discs) DVD-audio: Some DVD-audio discs allow the user to browse through images (photographs of the artist, lyrics, etc.) while music is being played. Use the or buttons to change to the previous/next page. Note that this is not availble on all DVD-audio discs. Other discs: Press or on the remote control to play slow forward or backwards. There are four speeds of slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY. NOTE: Slow play does not apply to audio CDs or DVD-audio discs. Cursor pad and OK button Use the cursor pad to navigate the On Screen Display (OSD) and menu pages. Confirm your selection with the OK button. Playback control Pause ( ), Play ( ) and Stop ( ) (see page 11). Fast play and Skip chapter/tracks Play fast ( ) and Skip ( ) chapters/tracks in both directions (see page 11). Advanced controls These buttons are described on the facing page. Standby Press Standby to toggle the standby state of the DVD player. Note that Arcam CD players are not controlled by this button. Advanced controls MEM (memorise) ZOOM Press ZOOM to enlarge a particular area of the picture. Each press of the ZOOM button increases the zoom, normally until a maximum of 4x enlargement is reached (although the amount of zoom possible varies depending on the type of disc: in some cases no zooming is possible). Pressing ZOOM when the maximum enlargement has been reached returns the image to normal...