Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
You can select a desired channel by pressing the CH/ Page or the number buttons. OPEN/CLOSE button 2 Insert a disc. Disc without a cartridge Insert with the playback side down. There are two kinds of disc size. Place a disc to fit the dish. If a disc is out of the dish, it may result in damage to the disc or malfunction. Place a disc in the inside hollow. DVD-RAM disc with cartridge (TYPE1/TYPE2/TYPE4) Single sided Turn the printed side up, and insert the cartridge into the tray frame following the direction of the arrow on the cartridge. Double sided Turn the desired recording/playback side up, and insert the cartridge into the tray frame following the direction of the arrow on the cartridge. 3 Close the disc tray. Press on the front panel or OPEN/CLOSE button on the remote control. Notes • Use the button on the front panel or the remote control to open and close the disc tray. Do not push or hold the disc tray while it is moving. Doing so may cause the recorder to malfunction. • Do not insert a disc which is unplayable, or any object other than a playable disc. • Do not apply downforce to the disc tray. Doing so may cause the recorder to malfunction. • If the disc tray stops while closing, the mechanical protection system of this recorder will open it. Do not force it to close. Doing so may cause malfunction. • If the disc tray would not open, turn the recorder off, and press button on the front panel or OPEN/CLOSE button on the remote control. This may turn the recorder on and open the disc tray. If it still wouldn’t open, contact your nearest TOSHIBA dealer. Turning the power off Press ON/STANDBY on the front panel of the recorder or on the remote control. The “Unloading” icon appears at the top right corner of the screen, and ON/STANDBY indicator turns red, then the power turns off (Standby mode.) Caution • If the power fails or the power cord is disconnected from a wall outlet while the recorder is in operation (ON/STANDBY indicator lit in green), the HDD or a loaded disc may become recording disabled. In such a case, executing an initialization of the disc using the formatting function of the recorder may refresh it. However, all contents stored on the disc will be completely erased by this initialization process. • This recorder may indicate alert messages with some DVD-RAM discs right after insertion. If such a disc is used for playback or recording on other equipment, all data in the disc may be damaged and the disc will not be played. By executing an initialization of the disc using the formatting function of the recorder, the disc will become operational. • If the recorder freezes and does not respond at all, leave it alone for about 15 minutes or longer. This may restore the recorder. After the recorder has recovered, turn it off once and turn it on again to use as usual. If the recorder is still inoperable after more than 15 minutes have passed, press and hold the ON/STANDBY button on the front panel for about 10 seconds or longer. The recorder is forced to quit and the power turns off. Turn the recorder on again and use it as usual. (This is an emergency measure, which may cause losses and/or damages of data. Avoid casual use of this measure. If you try this while the recorder is working properly, especially while the “Loading” or “Unloading” icon is flashing, it may result in initializing of the HDD.) (This 15-minute measure is available only when “Screen protector” is set to “On.” ( page 181)) Note • If there are any performance malfunctions of the HDD or the DVD-RAM drive, immediately discontinue use of this recorder, and disconnect the power cord from a wall outlet, then contact your dealer. Continuous use of the recorder in such a condition will aggravate the condition and result in increased cost and repair time. Disc tray lock (Child lock) You can lock the disc tray. Press and hold PAUSE on the remote control for longer than about 3 seconds. To unlock, press the button for longer than about 3 seconds. Note • Turning the power off also unlocks the disc tray. Introduction Recording Playback Editing Library Network Navi Function setupOthers 21 Introduction Before operating this recorder (Continued) Start-up/Shutdown (closing) icons These icons are displayed at the top right corner of the screen when startup or finishing. While they are flashing, the recorder is operating as follows: Loading Un loading Start-up, reading a disc, finishing the recording Unloading a disc, finishing the operation Open Close Opening a disc tray Closing a disc tray Status display Each time you operate the recorder, the following displays appear on the TV screen to indicate the status of the recorder. Status display e.g. Main on-screen displays (Depending on the disc, some of these may not appear.) : Playback : Pause : Stop : Fast-forward* : Fast-reverse* : Forward skip** : Reverse skip** x1/2 : Forward slow-motion x1/2 : Reverse slow-motion : Forward frame by frame playback : Reverse frame by frame playback : Re...
Эта инструкция также подходит к моделям:DVD-проигрыватели - RD-XS55KU (8.21 mb)