Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Printed in Taiwan. This publication is protected by copyright and all rights are reserved. No part or whole of it may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording without prior consent of I-Tech TECHNOLOGY CORP. The information in this document has been carefully checked and is believed to be accurate. However, I-Tech TECHNOLOGY CORP. assumes no responsibility for any errors that may appear in this document. The material contained herein is for informational purposes only. The information contained in this document is subject to change without any notices. Safety Precautions Before getting started, read the following important cautions. 1. The WBX-6200F-V may not come equipped with an operating system. An operating system must be loaded first before installing any software into the computer. 2. Be sure to ground yourself to prevent static charge when installing the internal components. Use a grounding wrist strap and place all electronic components in any static-shielded devices. Most electronic components are sensitive to static electrical charge. 3. Disconnect the power from the WBX-6200F-V before making any installation. Be sure both the system and the external devices are turned OFF. Sudden surge of power could ruin sensitive components. Make sure the WBX-6200F-V is properly grounded. 4. Turn OFF the system power before cleaning. Clean the system using a cloth only. Do not spray any liquid cleaner directly onto the system. 5. The WBX-6200F-V is not susceptible to intense shock or vibration. When assembling the WBX-6200F-V, make sure it is securely installed. 6. If opening the cover for maintenance is a must, only a trained technician is allowed to do so. Integrated circuits on computer boards are sensitive to static electricity. To avoid damaging chips from electrostatic discharge, observe the following precautions: • Before handling a board or integrated circuit, touch an unpainted portion of the system unit chassis for a few seconds. This will help to discharge any static electricity on your body. • When handling boards and components, wear a wrist-grounding strap, available from most electronic component stores. 7. Follow below instructions and notice the caution for replacing and disposing of the RTC Lithium battery CR2032 for safety consideration: CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instruction. Acknowledgments All product names or trademarks are properties of their respective owners. (This page does not contain any information) Table of Contents How to Use This Manual ................................................. IX Chapter 1 System Overview .............................. 1 Introduction................................................................... 1 Features........................................................................ 1 System Specification....................................................... 3 System View.................................................................. 4 I/O connectors 5 Unpacking ..................................................................... 6 Chapter 2 Getting Started.................................. 7 Setting Up the System .................................................... 7 Installing System Software .............................................. 8 Installing the Drivers....................................................... 9 Chapter 3 BIOS Setup Information.................. 10 Entering Setup..............................................................10 Main Menu....................................................................12 Standard CMOS Setup Menu ...........................................12 Advanced CMOS Setup ...................................................13 Advanced CMOS Setup Menu...........................................21 Advanced Chipset Setup Menu.........................................24 Power Management Setup Menu ......................................27 PCI/Plug and Play Setup .................................................30 Peripheral Setup............................................................31 Hardware Monitor Setup.................................................34 BIOS POST Check Point List ............................................35 Flash BIOS Utility ..........................................................41 Appendix A. Jumper Setting and Connectors List of CPU Board ................................................... 43 Jumpers Location and list ...............................................43 Jumper List...................................................................44 Jumper Setting..............................................................44 Connector Definitions.....................................................46 Connectors Location...........