Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
(3.4 kg) 14-15/16" (W)x 3-2/3” (H) x 12-3/16” (D) ■ 380 (W) x 93 (H)x 310(D) mm Note: Designs and specifications are subject to change without notice. 5 - WARNING- When using “Nut type" RF coaxial cables, tighten with fingers only. Overtightening may damage terminals. 6 Between Antenna and VCR Between VCR and TV Case 1 : Twin Lead Cable Only To VCR Terminal (Flat) Twin Lead 300 Ohm Cable 300*75 ohm T ransformer (not supplied) Case 1: Screw & Plug Type Terminal UHF/VHF Band TV Separator (not supplied) —Q RF Coaxial Cable VHF UHF Case 2: Twin Lead & Coaxial Cables Case 2: Screw Type Terminal (Round) 75 Ohm coaxial Cable UHF/VHF Band Mixer (not supplied) D To VCR Terminal Case 3: Two Twin Lead Cables (not supplied) To VCR Terminal If your TV has both post and plug-type VHF terminals, the post connection is recommended to minimize signal loss. TV Case 3: Double Screw Type Terminal TV UHF/VHF Band Separator (not supplied) H) VHF UHF Case 4: Complex TV Terminal TERMINALS ON BACK OF TV SET Connect to one of the ANT terminals and select the same antenna number on the TV. 7 Connections Other Connections CABLE Connections All connections on these pages are made with 75 Ohm coaxial cables. Without a Converter/Descrambler Box You can: 1) Use your VCR Remote Control to select channels. 2) Program one or more unscrambled channels for unattended recording. You cannot: record or view scrambled channels with this connection. IN FROM ANT. With a (CABLE to VCR) Converter/Descrambler Box You can: 1) Record and view any channel including scrambled channels; channel selection must be made at the Cable TV Converter Box. 2) Program one channel for unattended recording. You cannot: select channels from VCR or TV. watch one station while recording another, place channel in memory (pg.12) other than the cable box output channel. With a (VCR to TV) Converter/Descrambler Box You can: 1) Use your VCR Remote Control to select channels. 2) Program unattended recordings of more than one unscrambled channel. IN FROM CABLE You cannot: record scrambled channels with this connection. Cable TV Converter Box IN FROM ANT. OUT VHF/UHF With Two Converter/Descrambler Boxes If you want to record and view a combination of scrambled and unscrambled channels, you will need additional equipment. This connection requires two converter boxes, an A/B switch, and a 2-way splitter as shown here. Converter Box 1 8 With a DSS Receiver You can: 1) Record and view any channel including scrambled channels; channel selection must be made at the DSS Receiver. 2) Program one channel for unattended recording. NOTE: The DSS receiver must be turned off to view programs from a cable box or antenna. See the DSS manual for details. IN FROM CABLE or Antenna IN FROM Satellite Dish OUT TO TV VHFAJHF *DSS® is a registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics. Audio/Video Connections If your TV has AUDIO IN and VIDEO IN terminals, you can connect your VCR to them to receive a higher quality picture and sound. If your TV is not stereo, you can connect a stereo amplifier to the VCR to enjoy stereo sound. 1 Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV. 2 Connect the AUDIO OUT terminals on the VCR to the AUDIO IN terminals of your TV. 3 Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO." NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO." Note to CABLE system installer: This reminder is provided to call the CABLE system installer’s attention to Article 820-40 of the NEC in USA (and to the Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. 9 Connections Location of Controls Remote Control Buttons VCR- See pages 24,25. POWER- See pages 12,18,19, 24, 25. VCR/TV - See pages 12, 17, 23, 25. PLAY - See pages 16, 21, 25. SELECT UP See pages 13-15,18, 19, 22, 26. REWIND/ SEARCH See pages 16, 20, 21, 25. SET/BACKSPACE See pages 13, 14,18,19. ACTION- See pages 13-15, 22, 26. PAUSE- See pages 16,17, 23, 25. NUMBERED KEYS See pages 14,17, 20, 24, 25. DISPLAY/ENTER See pages 15,17, 22, 25. INDEX- See pages 20, 21. SPEED - See pages 17, 25. COUNTER RESET See pages 22, 25. - TV See pages 24, 25. DSS/CABLE See pages 24, 25. - INPUT See pages 17, 23, 25. FAST FORWARD/SEARCH See pages 16, 20, 21, 25. SET See pages 13-15, 18,19, 22, 26. - STOP See pages 14,16,17,19, 21, 25. SELECT DOWN See pages 13-15, 18,19, 22, 26. PROGRAM See pages 18,19. -RECORD/TIME See pages 17, 25. - SLOW See pages 16, 25. - ADD/DELETE See pages 14, 19. - CHANNEL UP/DOWN (TRACKING UP/DOWN) See pages 12-14, 16,17, 23. 25. VOLUME UP/DOWN See page 25. ZERO SEARCH/ 1...
Эта инструкция также подходит к моделям:Видеомагнитофоны/видеоплееры - PV8400 (1.14 mb)
DVD-проигрыватели - OMNIVISION PV-8200 (1.14 mb)