Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
– Pay attention to the fact that the door is not unlocked until at a temperature of 150 °C or less. Tip: wait until the appliance indicates that the pyrolysis process has ended. This ensures that you will achieve an optimum cleaning result. Starting pyrolysis at a later time: – Enter the required switch-off time (see Chapter 3). – T urn the control knobs to the pyrolysis setting as described above. Note: you can query the current pyrolysis time by pressing the (Timer) key. You can increase the length of the pyrolytic cleaning process during operation. Press the + key to increase the value by 30 minutes in each case. Confirm the value by pressing the (confirmation) key. 7. Maintenance 7.1 General 7.2 Replacing the lamp Fig. 42 Fig. 43 The appliance must always be disconnected from the mains when being repaired. If the appliance does not function correctly, check the fuses first. If the power supply is functioning correctly, but your appliance still does not work, please contact your dealer or your local Gaggenau customer service agency. Specify the appliance type (see rating plate). Repairs may only be carried out by authorised electricians, in order to guarantee the safety of the appliance. Unauthorised tampering with the appliance will invalidate any warranty claims. You can obtain spare lamps from Gaggenau Customer Service or a dealer. We recommend that you use these lamps only. (Order number 157312) Proceed as follows: – Disconnect fuses. – Remove one of the lamp cover screws. – Swivel the cover to the side. Caution: the lamp cover may still be hot. – Push the lamp to the side by about 4-5 mm. The lamp can now be titled down and removed. – Insert the lamp in the reverse order. Swivel the cover back to its original position and screw it on. (Caution: secure the seal properly!) Note: do not touch the halogen lamp with your hands. Use a cloth and only touch the edges of the lamp. 32 7.3 Disassembly of the front window The oven door is actively ventilated. Dust and grease particles may therefore settle after some time. Detach the front window to remove this soiling. Proceed as follows: – Remove the bottom screw from the door handle. – Remove the top screw from the door handle and detach the door handle. – Hold the front window with one hand and lightly shake the door to and fro. The glass window can be removed towards you. You can now clean the front window. Install in the reverse order. In doing so, make sure that you first insert the window on the left hinge side and that you hold it with one hand to stop it from falling out. Fig. 44 Fig. 45 8. Assembly instructions 8.1 Technical data Rating: 230 V AC, 16 A Heating power: Infra-red grill Hot air heating element Top heat Bottom heat Power circuit 3100 W 2300 W 1100 W 1100 W 3600 W Dimensions: Outer 590 x 590 x 550 mm Inner 460 x 365 x 400 mm You can order the following spare parts by stating the specified numbers: Baking plate KB 200-046 Grid iron GR 200-046 Grilling tray GP 200-046 Halogen lamp 157312 Technical modifications without notice. 8.2 How to do it The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. The electrician is responsible for the correct functioning of the appliance at the time of installation. He should instruct the user on how to operate the appliance correctly on the basis of the Operating Instructions, and the user has to be instructed on how to disconnect the appliance in an emergency. We accept no liability for damage caused by failure to comply with these instructions. If it is not possible to disconnect the appliance from the mains via an easily accessible plug and permanent cable connection, an isolating switch with a contact clearance of at least 3 mm must be fitted on the installation side. Repairs carried out improperly may involve substantial risks for you. Connection to the power mains: On the top of the appliance there is a cover that has to be unscrewed. The wiring diagram stuck onto the top of the applian...
Эта инструкция также подходит к моделям:Духовые шкафы - EB261111/03 (2.43 mb)
Духовые шкафы - EB261111/10 (2.43 mb)
Духовые шкафы - EB261111/11 (2.43 mb)
Духовые шкафы - EB261111/12 (2.43 mb)