Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
. The surfaces of heating and cooking appliances get hot during operation. The interior oven walls and the heating elements get extremely hot. Always keep children away from the appliance. . Never leave the appliance unattended when cooking with fat or oil. They can catch fire if overheated. . Clean the oven regularly. Fatty or oily remants could ignite when the oven is switched on. . Make sure that the power cord never comes into contact with the hotplates, and does not get caught in the hot oven door. The plastic insulation could melt. . In the case of a defect, switch off (or remove) the mains fuse in the building electrical system. . Do not store combustible items in the oven. They could ignite if the oven is switched on accidentally. . Do not clean the oven with steam or high-pressure cleaners. Telescoping extension rails: . Always fully push the extension rails together. A slight resistance during sliding in and out is normal. . Close the oven door only after all extension rails have been fully pushed together. . Caution: The extension rails heat up during oven operation. Use special care to avoid burns when extending the rails. . If using hot air v, do not place greaseproof paper loosely in the oven (e.g. when heating the oven). The hot-air fan could draw in the paper which may damage the heater and fan. . Do not insert a baking sheet at the bottom of the oven, or cover it with aluminium foil, because a heat build-up would result. Roasting and baking times would change, and the enamel would be damaged. . Never pour water directly into the hot oven. Damage to the enamel could result. . Fruit juices dripping from the baking sheet leave spots that cannot be removed later. For baking, use the deeper universal baking pan. . Never stand or sit on the open oven door. . The oven door must close properly. Keep the door sealing surfaces clean. Introducing: Your new Cooker Heating-up monitor Oven functions Electronic clock Rotary control / main switch (pops out) for all temperature settings and for setting the electronic timer Control panel: . The rotary control / main switch can be retracted. . Press the middle of the knob to release or push it inwards. . All appliance functions are disabled while the knob is retracted, with the exception of setting the time of day. Oven functions: v Hot-air and defrosting position I Combination hot-air/ surface grilling (press 2 times) e Top/bottom heat (conventional heating system) w Bottom heat (press 2 times) 0 Surface grilling, full-surface grill Z Surface grilling, centre-area grill (energy-saving grill) S Dough-proving setting n Bread-baking position (press 2 times) x EasyClean® system (Oven cleaning system) . Symbols on the control panel are illuminated. As soon as you select a particular function, the corresponding symbol lights up. Note: . The oven light switches on for every oven function. Exception: Oven cleaning. . The heating-up monitor indicates how far the oven has heated up. 1 Baking tray, enamelled 1 Wire shelf 1 Universal pan with grid 1 Roasting tray Universal pan with grid Z 1230 X2 Souffle pan Z 1270 X2 Baking tray, aluminium Z 1330 X0 Baking tray, enamelled Z 1340 X2 Wire shelf, high/low Z 1470 X0 Roasting tray (only for use with Universal pan) Z 1510 X2 Pizza stone Z 1910 X0 Radio antenna for electronic clock Z 1980 X0 Note: . The baking tray or universal pan may distort while the oven is operating. This is caused by major temperature differences on the utensil. These differences may occur if only one part of the utensil was covered or if deep-frozen food, e. g. pizza, was placed on the utensil. The distortion will already subside again during baking, roasting or grilling. Slide-in levels . Your oven features 4 slide-in levels. The slide-in levels are counted from bottom to top. The numbers are marked in the oven. When using hot-air baking or roasting, do not use slide-in level »2«, in order not to block air circulation. Introducing: Your new Cooker Accessories . Your appliance is supplied with: Order no. . The following accessories can be obtained from a specialist dealer: Before Using Your Appliance for the First Time Time of day . Before you use your appliance for the first time, it is necessary to set the current time on the electronic timer. . After connecting to the mains, or after a power failure, the display {:{{ will blink. Setting the time: Setting the time of day: 1. Press the middle of the rotary control so that it pops out. 2. Press the + button for setting the time of day. . The arrows above the rotary control flash. Note: The time cannot be set if an automatic function is active (see Electronic clock for cancelling automatic function). 3. Turn the rotary control to set the time of day (e.g. |A:{{ Uhr). . The time setting has been programmed as soon as the light illuminating the arrows above the rotary control goes out. Acknowledgement signal . It is possible to set the appliance so that an acknowledgement signal is heard every time a but...
Эта инструкция также подходит к моделям:Духовые шкафы - B1693N2/05 (1.25 mb)