|
Фрагмент инструкции
The edges of thin trays cannot be completely enamelled. As a result, these edges can be rough. Anti-corrosion protection is guaranteed. EasyClean® Function selector The oven cleaning function featured in your oven is intended to help you keep your oven neat and tidy. An amount of cleaning solution is vaporised automatically. The combined effects of heat and steam soften the soil deposits on the oven wall enamel and facilitate their removal. Caution: Use this function only after the oven has completely cooled (room temperature). Use normal water only, and no distilled water. Activate oven cleaning: 1. Remove the baking sheet and the universal baking pan from the oven. The baking grill may remain in the oven. 2. Pour approx. 400 ml of water mixed with a little dishwashing detergent into the floor pan of the oven cavity. In the case of heavy soil build-up, you may wish to allow the cleaning solution to soak in for a while before you activate the cleaning function. 3. Close the oven door. Warning: The cleaning system can only be activated when the oven has cooled down completely. 4. Turn the function selector until ”EasyClean” appears on the display. The (indicator lamp lights up, and ”operating” appears on the display. When ”EasyClean” flashes on the display, the oven has not cooled down completely. When EasyClean has ended, an acoustic signal is emitted, and ”Ended” appears on the display. Switching the oven OFF: Turn the function selector to the 0 position. After deactivating the oven Cleaning tips: cleaning function Never leave the residual water in the oven for any length of time, e.g. overnight. 1. Open the oven door and pick up the remaining water with a large absorbent sponge cloth. 2. Using the detergent-soaked sponge cloth, a soft brush or a plastic pot scrubber, wipe of the oven interior. Stubborn soil remnants can be removed with a cleaning scraper for glass-ceramic. Caution: Use the scraper carefully, and do not apply the tool at too flat an angle, because the enamel could be scratched! 3. Calciferous deposits may be removed with a cloth soaked in vinegar. 4. Wipe clean with clear water and dry with a soft cloth (do not forget to wipe under the oven door seal). Cleaning tips: If the oven is heavily soiled, the procedure may be repeated after the oven has cooled. If the oven is heavily soiled with grease, e.g. after roasting or grilling, we would recommend rubbing any stubborn dirt with detergent before activating the oven cleaning function. After cleaning, leave the oven door in its slanted detent position, i.e., at a 30-degree angle, to allow the interior enamel surfaces to dry thoroughly. Rapid drying 1. Place the oven door into the slanted detent position, at an angle of approximately 30 degrees. 2. Turn the function selector until ”Circotherm” appears on the display. 3. Reduce the oven temperature with the temperature selector until 50° C is displayed. 4. Duration: approximately 5 minutes. 5. Then switch the oven off. 89 Unhook oven door 1. Push the lock bolt to the left and right, inwards and open the oven door until it is in a slanting position. 2. Hold the oven door at the top and at the same time slightly lift the handle. 3. Remove the oven door in a slanting position upwards. 1. 2. 3. 3. Hang in the oven door 1. Place the oven door in a slanting position over the guide rollers. 2. Lift the handle slightly until it is in a horizontal position, until the oven door slots into place. 3. Close the oven door and push the lock bolt to the left and right, outwards. 1. 2. 3. 90 Lowering the heating element In order to clean the oven ceiling more easily turn down the grill heating element. Warning: The heating element must have cooled down. 1. Press the retaining clip upward until you hear the click. 2. Hold the heating element and fold it down. After cleaning Fold the heating element back up. Pull the retaining clip forward and press it up until it clicks into place. Inset rack Removing 1. Pull the inset rack out of its bearing bush. 2. Remove the inset rack. Clean the rack using washing-up liquid and pan scrapers or brushes. Telescopic pull-outs Removing Hold the leaf spring and push the telescopic rail ds. Clean the telescopic pull-outs using washing-up liquid and pan scrapers or brushes. Insert the telescopic pull-out at the rear. Insert the telescopic pull-out into the guide and press down until it locks into position. Always insert the telescopic pull-outs all the way. Do not close the oven door until all telescopic pull-outs have been inserted. Attention: The telescopic pull-outs become hot when the oven is on. Risk of burns when the telescopic pull-outs are pulled out. 1. Pull the leaf spring. Attaching Service and Repair Information In the event of problems or repairs that you cannot solve or perform yourself, our customer service will be happy to help. Check the customer service directory for a customer service facility in your area. Caution: Calling the customer service because of an oper...
Эта инструкция также подходит к моделям:Духовые шкафы - B16H2A0/03 (3.13 mb)
Духовые шкафы - B16H2A0/08 (3.13 mb)
Духовые шкафы - B16H2A0/10 (3.13 mb)
Духовые шкафы - B16H2N0/01 (3.13 mb)